Where is the battery located on a Honda Pilot?
The car battery is placed on the right side, under the hood.
Do you need serial number for Honda Pilot?
You will also need a serial number to get your unlock radio code. The serial number does not apply to the vehicle—it is attached to the device you want to unlock. 2013 and 2014 Honda Odyssey and Honda Pilots do not require a radio unlock code.
How to reset my Honda radio after putting in a new battery?
Step 1 Turn the ignition key to the “On” position, but don’t start the engine. Turn the radio on by pressing in on the volume control knob. After 10 seconds, turn the radio off. Press and hold the power button for two to five seconds and watch the radio display. Release the power button when the display lights up and the radio turns on.
Do you need to enter your Honda radio code?
When you replace your car battery, you may need to enter your Honda radio codes to activate your radio. This might even be required for a simple disconnection or complete draining of your battery. Usually, you can activate your radio battery by hold pressing the power button for about 2 seconds. However, this method will not always work.
Why does my Honda radio lock up after battery is disconnected?
After a silent drive home I researched what had happened and found out that newer Honda radios have a theft-deterrent feature whereby after being disconnected from the battery they “lock up” and won’t work again until a security code is entered. My owner’s manual told me I should have received this code number with my owner’s manual kit.
Step 1 Turn the ignition key to the “On” position, but don’t start the engine. Turn the radio on by pressing in on the volume control knob. After 10 seconds, turn the radio off. Press and hold the power button for two to five seconds and watch the radio display. Release the power button when the display lights up and the radio turns on.
You will also need a serial number to get your unlock radio code. The serial number does not apply to the vehicle—it is attached to the device you want to unlock. 2013 and 2014 Honda Odyssey and Honda Pilots do not require a radio unlock code.
How do you put a radio on a Honda Accord?
Go to https://radio-navicode.honda.com/ and click on the tab labeled “Get codes.”. Input your radio’s serial number, vehicle’s VIN and your personal information, then click “Submit.”. Write down the security code. Turn the ignition switch to the “On” position and turn on the radio.
How do I find the code on my Honda radio?
Turn on the audio unit. COdE should display. If it does not display, pull the backup fuse for one minute and try again. Turn off the unit. Press and hold the tops of each of the SEEK/SKIP and CH/DISC bars. At the same time, press and release the PWR/VOL knob. The code screens should then appear.