What is the code for the brake light switch on a Subaru?
The bulletin pertains the vehicles and Subaru ABS trouble codes listed below and advises shops and DIYers of an updated brake light switch. There’s lots more information on this site for your Ford vehicle. C1531 or C0054 along with ABS, VCC or HSA warning light.
Why is the brake light not working on my Subaru Outback?
Subaru has determined that the dielectric silicone grease in the plunger area can actually reduce contact conductivity to the point where the brake light switch cannot provide a reliable ON/OFF signal. When that happens, the ABS, Hill Assist, Eye Sight and the Subaru Vehicle Dynamics Control systems don’t work properly.
Where can I get a new brake light switch?
The new brake light switch is part # 83311FJ001 and is available from the Subaru dealer. The problem switch body has a grey color, while the replacement switch is blue with a green paint dot identification.
Why are there warning lights on my Subaru?
Drivers will see illuminated warning lights associated with any features that are experiencing problems. Subaru traced the problem to a report in March 2012 that involved warning lights that illuminated due to a failed brake light switch. The switch was analyzed and engineers determined the switch failed because it was coated with oxidized silicon.
Is there a recall on a Subaru brake light switch?
Brake Lamp Switch Recall At the end of February 2019, Subaru recalled brake light switch in 2.3 million vehicles, including the 2013-2017 Crosstrek, 2014-2016 Forester, 2008-2016 Impreza (4-door), 2012-2016 Impreza (5-door), and 2008-2014 WRX (4-door).
How do you install a brake light switch?
Line up the holes with the notches on the switch and insert the switch. Step 2: Lock the switch. Rotate the switch in the clockwise direction to lock it in place. Note: While installing the switch you may have to press down on the brake pedal in order to insert it all the way.
Is there a problem with the brake light switch?
In November of 2016, Subaru released a Technical Service Bulletin (TSB) outlining a design change to the brake light switch to reduce the possibility of improper illumination of the ABS and/or VDC warning lamp. To fix the problem, Subaru introduced a new switch with fluorine grease to lubricate the plunger and prevent silicone contamination.
How much does it cost to replace a brake light switch?
Brake light switch replacement. The part is not very expensive ($15-$45) and can be ordered from a dealer or online. The replacement of a brake light switch in a repair shop can cost from $55 to $115 (part and labor).