How do you turn off cruise control on a Subaru Tribeca?
There are two ways to turn off the cruise control: Push the main switch again. Turn the ignition switch to the “Acc” or “LOCK” position (but only when the vehicle is completely stopped).
What does the Check Engine light mean on a 2007 Tribeca?
Similar error lights, but my 2007 Tribeca had a torque converter throwing metal into the transmission. Had to be towed in and full tranny and torque converter replacement. Anytime the check engine light comes on, the ABS light, flashing cruise light and non-operational cruise control does as well.
What’s the problem with my Subaru B9 Tribeca?
I have Subaru B9 Tribeca 2006. Week ago started the following problems – after starting up, engine is shaking (rough idle) for a few (20-30) seconds and then it’s OK. Then I got Check Engine, Cruise and ABS lights on. Diagnose shows mistake in 1st cylinder. changed spark plug, air filter, checked all connections, cleaned injector and throttle.
Why is my cruise control light flashing on YouTube?
Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred. Please try again later. (Playback ID: U9FaPAhihqnmoR1p) An error occurred while retrieving sharing information.
When was the first time my Tribeca had a problem?
I have a 2006 Tribeca – bought new – and have had this issue a few times. The first time it happened was about 3 years ago (past warranty time), I luckily had a good mechanic who had worked at a Subaru dealer, so when I told him the problem, he said it’s often one of Subaru’s glitches and to unhook the battery for about 20-30 min so it could reset.
Similar error lights, but my 2007 Tribeca had a torque converter throwing metal into the transmission. Had to be towed in and full tranny and torque converter replacement. Anytime the check engine light comes on, the ABS light, flashing cruise light and non-operational cruise control does as well.
I have Subaru B9 Tribeca 2006. Week ago started the following problems – after starting up, engine is shaking (rough idle) for a few (20-30) seconds and then it’s OK. Then I got Check Engine, Cruise and ABS lights on. Diagnose shows mistake in 1st cylinder. changed spark plug, air filter, checked all connections, cleaned injector and throttle.
What was the CEL and blinking cruise light in 05?
JF, our ’05 set-off the CEL and blinking cruise light twice following a loss of power which brought the vehicle down to 10 – 15 kph. Both times it coded a faulty accelerator assembly. This (ghostwalking) car is now on its 3rd accelerator assembly.
Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred. Please try again later. (Playback ID: U9FaPAhihqnmoR1p) An error occurred while retrieving sharing information.
How do I reset my Subaru dashboard?
Using the camera, set it to record and point it at the engine error light on the dashboard. Then turn the key rapidly to on, then off, turn it on and off, then on again and then off, then on position in five seconds or less. This should look like this.
I have a 2006 Tribeca – bought new – and have had this issue a few times. The first time it happened was about 3 years ago (past warranty time), I luckily had a good mechanic who had worked at a Subaru dealer, so when I told him the problem, he said it’s often one of Subaru’s glitches and to unhook the battery for about 20-30 min so it could reset.
When did I buy a used Tribeca car?
2008 tribeca bought used 2 years ago. Low mileage, one owner, extended warranty. Exact same codes/issues and have been trying to find fix since this past spring. It’s been into the dealership three times. First “fix” held for less than 24 hours.