What do the warning lights on a Subaru Outback mean?
A failure of the tire pressure monitoring system (TPMS) is indicated by the warning light flashing on the dashboard for about 1 minute, then remaining on. Tires, including the spare (if provided) should ideally be checked once each month and when cold.
What happens to OBDII code on Subaru Outback?
If the battery is disconnected to clean the terminals, any record of that code will be erased, and if there is a fault, it could take some time for the OBD to trigger the code once again. Most national chains can read your OBDII codes (check engine light) and check battery/atlernator voltage for free.
When do the warning lights on the dash reset?
If it’s the gas cap, it takes several drive cycles before the warning lights will reset. Or you can check the codes, write them down (!) for future reference, and then clear them. If it’s the gas cap, it takes several trips before the warning lights will reset. Click to expand… ammcinnis – I think you were right.
When does the parking brake warning light go out?
Name: Subaru Outback electronic parking brake warning light. Description: Under normal operating conditions, the electronic parking brake warning light illuminates when the parking brake is applied and with the ignition set to the ‘on’ position and goes out when the parking brake is released.
What does the battery warning light on a Subaru Outback mean?
Name: Subaru Outback battery warning light. Description: If the battery warning light comes on when the engine is running, it indicates a fault in the charging system. If the battery warning light stays on after engine start, stop the engine and check the alternator belt.
What’s the problem with my 2014 Subaru Outback?
Had the same problem with my 2014 Subaru 3.6R Limited. Brake light flashing, cruise control flashing and check engine light on. Checked gas cap and cleaned battery terminals did not solve the problem. Refused to go to my Subaru dealer, to be ripped off a third time I went to my local neighborhood mechanic. Problem solved!
If the battery is disconnected to clean the terminals, any record of that code will be erased, and if there is a fault, it could take some time for the OBD to trigger the code once again. Most national chains can read your OBDII codes (check engine light) and check battery/atlernator voltage for free.
What are the different colors of Subaru warning lights?
They are roughly ordered by importance, which tends to be by color (red, amber, yellow, orange, green, blue, gray), but there are nearly 70 of them so be patient! Models examined include Ascent, BRZ, Crosstrek, Forester, Impreza, Legacy, Outback, Tribeca, and WRZ.
A failure of the tire pressure monitoring system (TPMS) is indicated by the warning light flashing on the dashboard for about 1 minute, then remaining on. Tires, including the spare (if provided) should ideally be checked once each month and when cold.
When did I change the battery in my Subaru Outback?
And starting in the early 90s, with the OBD and OBD2 system, they all had issues at first startup, and had a driving process to re-program the OBD2 system. That’s why I got the battery backup gizmo after changing the battery in my 09 Outback.
Why does my car alarm go off when I open the door?
It does not care what key is being used, as there is no transponder/code in the key. If the alarm is armed, it will go off if the door is opened regardless of what key is used, or if it were broken into. See my post #4 above for the solution to this problem.
How to check the oil level in a Subaru Outback?
1. Pull off the road when safe to do so and stop ideally on a level surface. 2. Wait a few minutes for the oil to drain into the oil pan. 3. Open the hood and remove the dipstick (1). Wipe the end of the dipstick clean with a cloth and replace it. 4. Remove the dipstick again and check that the oil level is between the MIN and MAX marker. 5.
What are the possible causes of p2102 engine code?
P2102 Possible Causes 1 Dirty throttle body 2 Faulty Throttle Actuator Control Motor 3 Throttle Actuator Control Motor harness is open 4 Throttle Actuator Control Motor circuit poor electrical connection 5 Faulty Throttle Actuator Control Motor Relay 6 Faulty Engine Control Module (ECM)
How much does it cost to diagnose a p2102 code?
The cost to diagnose the P2102 code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How to diagnose a p2102 throttle actuator low?
Start by checking the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost to diagnose the P2102 code is 1.0 hour of labor.
Why does my AWD warning light keep flashing?
It flashes if the vehicle is driven with tires of differing diameters fitted on the wheels or with an excessively low air pressure in any of the tires. Continuing to drive with the AWD warning light flashing can damage the powertrain.
Why is the Check Engine light flashing on my Outback?
The On Board Diagnostics or OBD-2 for short only sets a check engine light when the ECM or Electronic Control Module reads a sensor value either too high or too low, but it has to read that same fault 3 consecutive times in a row to turn on the check engine light (w/ flashing cruise).
What does the all wheel drive warning light mean?
This light illuminates when All-Wheel Drive is disengaged and the drive mechanism is switched to Front Wheel Drive for maintenance or similar purposes. It flashes if the vehicle is driven with tires of differing diameters fitted on the wheels or with an excessively low air pressure in any of the tires.
Why are my brake lights flashing on my Subaru?
Enter your ride HERE to be a part of this month’s Outback of the Month Challenge! I’ve been having an issue lately with my dash lights flashing. The brake light and cruise control flash while the check engine light and traction control light stay lit. After a few days, it will all go back to normal and the flashing stops.
Why does my Subaru Outback light up like a Christmas tree?
Yes it just wiped the codes for a easy fix. Then he finally took it to get the codes ran after it happened 2 more times. It read Transmission, CVT, Torque converter. Which the dealership just fixed the Torque Covertor last year so I decided to trade it in for a 2019 crosstrek because I owed a year and didn’t wanna have it towed in and still owe!!!
How often do Subaru dash lights go off?
Lights used to flash for 24 hours and go off. Now it’s 48 hours on but happening every two days. I will tell my mechanic to reset the obi 4 digit codes as you have suggested.
What does DTC mean on a Subaru Outback?
When any DTC (diagnostic trouble code) is set all these lights come on to get the drivers attention. The cruise control is disabled as the vehicle now has a “fault” and Subaru engineers are not happy to have a faulty vehicle operating under cruise control.
What was the problem with my Subaru Outback?
Thought maybe parking brake got turned on during travel…hoping not computer 29 people found this helpful. I have a 2010 Subaru Outback. First time it happened, about a year ago, found out the gas station didn’t put the gas cap back on. It then happened again 2 months ago. Took it to my mechanic.
How to replace a Subaru Outback instrument panel light?
This is a quick how to replace the Instrument Panel Light if yours has burned out. It’s cheap and relatively easy. Just a little time consuming from being buried in the dash so far. Hopefully this helps someone! If you have one burned out I would recommend replacing all 4 because of how hard they are to get to. Loading…
Is there a YouTube channel for Subaru Outback?
Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. This channel is mostly me having fun. It can also be me showing how to do things and how not to do things. I hope you enjoy it. Subaru Outback P0455 Code Fix! Disable Check Engine Light.
Where does the SBF come from in a Subaru Outback?
It’s supplied from SBF-1, 100 Amps, which is connected to the battery positive. 1) Seat heater (in-line) fuse (if the car is equipped with heated seats) which in turn feed power to the seat heater relay, and thence to the seat heater switch and heaters.