Why does my radio turn on but no sound comes out?
Exactly, check for exposed wiring, if and when you find it, tape it up. If thats not the case, I would say you have 1 or more loose wires connecting to the back of the radio, sometimes 1 or 2 wires that are in a plug get loose or a bad connection and can mess the whole thing up like that. Have a look at all your wiring.
How can I diagnose a Honda transmission problem?
A scanner that can diagnose Honda transmission problems. Here are a few popular choices. These scanners can read and clear fault codes from the transmission module. Locate the OBD-II port under the dashboard. Turn on the ignition. Allow your scanner to turn on. Select your Honda model, then go to the Control Unit.
What causes Honda transmission to reboot at low voltage?
Low voltage can cause the TCM to reboot, which places the transmission in Park or Neutral. Honda issued a recall for this problem where a software update changes the behavior on TCU reboot. NHTSA campaign number: 19V299.
Why does my Honda CRV stereo make a whining noise?
Stereo Making Whining Noise If your CR-V’s stereo is making a whining noise, it is usually caused by a condition known as “alternator whine”. Alternator whine is a product of a drop in voltage between the radio and the alternator itself. It is usually way more noticeable on the A.M band of the radio.
How to reset the radio number on a Honda CRV?
4-Press and hold the number 1 and number 6 radio preset buttons, and then turn ON the radio. 5-The display will toggle between two different screens: there is a U with the first 4 digits of the serial number (U4637 just as an example,) and L with the last 4 digits of the serial number (L9873 just as an example.)
What to do when your radio is not working on Honda Accord?
The solution is very simple,Just try to close the rear speakers ( continuously press the “sound” button for three times, then rotate the “volume” button to adjust the Balance/Fader ,makes sure all sound are came from front speakers) . Then try to reopen the radio and wait a while, the sound will be back!
How to reset the radio antitheft code on your Honda?
3-Turn OFF the radio. 4-Press and hold the number 1 and number 6 radio preset buttons, and then turn ON the radio. 5-The display will toggle between two different screens: there is a U with the first 4 digits of the serial number (U4637 just as an example,) and L with the last 4 digits of the serial number (L9873 just as an example.)
What to do when your car radio has no sound?
Usually when this happens though the radio will lose all power and you won’t have sound at all. Verify your fuses behind the radio, and in the vehicles fuse panels as well. Replace any blown fuses and see if the radio kicks on and produces sound. If you have power to the radio officially but yet you still have no sound, then continue on.
Why does my Toyota Corolla radio have no sound?
Please try again later. An easy fix for a 2010 Toyota Corolla radio with no sound. I found a speaker wire in the trunk broke loose from its retainer and shorted on the speaker frame. There are no protective covers around the speakers, and large items in the trunk may hit them. Loading…
Why is the radio not working on my Volvo?
The radio was working then suddenly sound just stopped. I turned the radio off, pulled it out and fiddled with the connections in the back. Turned the radio back on and it worked fine. The next day on my drive into work the radio stopped again. This time no amount of messing around with wires, disconnecting and reconnecting worked.
Is the radio still working but no sound from the speakers?
Vocational, Technical or Tra… 2002 dakota with RAZ cd/tape radio no longer has sound from front speakers. Now, 1 of the rear speakers is going in and out. … read more
Usually when this happens though the radio will lose all power and you won’t have sound at all. Verify your fuses behind the radio, and in the vehicles fuse panels as well. Replace any blown fuses and see if the radio kicks on and produces sound. If you have power to the radio officially but yet you still have no sound, then continue on.
Why is my radio on but no sound from the trunk?
Both radios come on, and can change screens, and the back up camera works too. This is a VAN, so there isn’t any amp in the trunk. No sound in any of the speakers. The connections to the car wiring are good, and even blew out the connections with compressed air to ensure a clean seating with the wiring.
Why is the radio not working in my 2005 Land Rover?
Radio works, but no Sound out of speakers? My 2005 LR3 has no sound out of the speakers, however, the radio/CD player are on and seem to be working. This has happened in the past, and the solution has been to turn the car off and then turn it back on. It just happened again today.
Exactly, check for exposed wiring, if and when you find it, tape it up. If thats not the case, I would say you have 1 or more loose wires connecting to the back of the radio, sometimes 1 or 2 wires that are in a plug get loose or a bad connection and can mess the whole thing up like that. Have a look at all your wiring.
Why does my pioneer stereo not produce any sound?
At this point, the stereo doesn’t send any signal to the speakers. The unit powers on and reads CD’s just fine, but refuses to make any kind of sound. Any ideas? Answered! View the answer I have this problem too
When did the sound on my Radio stop?
When it happened, the sound was slightly distorted and then just disappeared instantly and has stayed away. The radio is meant to be of reasonable quality and is only about 18 months old. Any pointers would be greatly received.
Can you repair a radio that has stopped working?
YOU MUST NOT ATTEMPT TO REPAIR THE RADIO YOURSELF UNLESS YOU ARE LEGALLY ALLOWED TO DO SO. The faults can be loosely categorised in two groups. Failures and age. If it was the year 1950 and your near-new radio has stopped, you would look for a failed component.
Why is there noise in my car stereo?
There is noise, cracking sound, static or no audio through the speakers of the car stereo system. Noise in your car audio system can be caused by more than one issue. Noise can be static, whine, hiss, distortion, or other sound issues. Make sure to check ground wires . Check the ground wires to all of the components in your system.
What to do when there is no sound in your car?
If you have extended the ground wire, make sure the splice is firmly connected and you may need to use a larger gauge (thicker) ground wire. Turn on your audio system without the car running. Put in a CD and set the CD player on pause, or insert a blank tape if you have a cassette deck. Turn up the volume to a normal listing level.
Why is my radio on but there is no sound?
Radio comes on, no sound (or it would make a loud static sound if you hit the radio or ramdomly on it’s own), everything else is fine, display, CD works etc.. So I bought an identical used replacement radio on ebay, still not working and the same problem.
Why is the sound not working on my Toyota?
This Toyota has an entertainment fold-down DVD player that was installed at the dealer. SYMPTOM: Head unit appears to be work, however no sound is playing through any speakers. Also, entertainment fold-down DVD player is not working. PROBLEM: Toyota head unit is designed to stop playing sound upon any connection errors.
Why is the radio not working on my corolla?
Our 2012 Corolla lost all sound but the radio still showed as working including bluetooth, CD, etc. My husband had put tires in the trunk to get our snow tires changed and sure enough knocked off the speaker wire and it grounded out.
What to do when your car has no sound?
SOLUTION: Disconnect the axillary device on rear of head unit, check speaker connectors (especially if your Toyota type has a trunk as the speaker clips are exposed and can be *hit by items in the trunk). In my specific situation, the Toyota installed DVD player in the back malfunctioned and put the head unit in this (NO SOUND) mode. Good luck.
What to do if your car stereo has no sound?
Radios have all sorts of wires going in and out of them. Each wire serves a specific purpose for the car stereo to operate correctly. If you have a car stereo that has no sound than we should start by checking that all the wires are hooked up. A car stereo will always have 3 different power wires going to the deck section.
Why does my Mercedes 350 have no sound?
My ML 350 is not having sound but everything lights up. Trying to see if I can tighten The NO SOUND problem is a known issue with ML’s. It is caused by an internal fault with the fiber optic connection. I sold the MCS. I really didn’t like the way it was designed for the right-side drive as it was.
Is the blue wire on my speakers grounded?
That would be a remote turn on wire. It turns on an amp or other acc when the head unit turns on. Unless you have an amp that is powering those speakers, the blue wire isn’t your problem. exactly. you have a grounded speaker wire. if you have aftermarket speakers I would check there 1st.
Why is the radio not working on my Mercedes Benz?
Is the radio on your Mercedes-Benz not working? Some common problems with the Mercedes-Benz COMAND system include issues such as: Radio panel doesn’t turn on. (Hint: Check fuses.) The fist thing you should try is to do a soft reset of the COMAND unit.
My ML 350 is not having sound but everything lights up. Trying to see if I can tighten The NO SOUND problem is a known issue with ML’s. It is caused by an internal fault with the fiber optic connection. I sold the MCS. I really didn’t like the way it was designed for the right-side drive as it was.
What do you do when there is no sound coming from your radio?
Started the car, pulled the fuse, waited one minute, turned OFF the car, put the fuse back in, restarted the car. Everything worked great. BTW, it is the 20A Multimedia Fuse on the 2013 Elantra Ltd. 59 people found this helpful. Paper clip also worked For 2012 Elantra Ltd.
Why does my Mercedes E430 have no audio?
1) The Mercedes E430 contains all the components in the fiber optic system in the trunk, driver’s side wheel well. Except the stereo. We have found no particular pattern for which equipment is next in the fiber optic loop. 2) Removing the fiber optic cable from the stereo or amplifier will cause no audio output.