When do you need a Chevy S-10 ignition coil?
When you need a new Chevy S-10 ignition coil, make AutoZone your destination. Serving to convert currents from your truck’s battery to energy that is useable by its spark plugs, ignition coils for Chevy S-10 are a truly vital component.
How much does it cost to replace an ignition coil?
An ignition coil typically costs $70-$375 or more depending on the make and model of vehicle, if it is a single coil or a coil pack, and whether the part is made by the vehicle manufacturer (called OEM parts, and typically more expensive) or an aftermarket product from a company other than…
What should the voltage be on an ignition coil?
If you do not see sparks, check the output on a voltage/ohm meter. The primary coil should produce readings between 0.7 and 1.7 ohms. Aftermarket ignition coils are built to different specifications and tolerances that can affect the performance of the ignition system.
Where are the electrical contacts on an ignition coil?
Position the leads of the ohmmeter on the poles of the primary coil. The distributor will have three electrical contacts – two on either side and one in the middle. These may be either external (jutting out) or internal (sunken in) – it makes no difference.
Where are the fuses on a Chevy Caprice?
The fuses are located behind the cover on the driver’s side of the dash panel. Underhood Light, Power Antenna, Keyless Entry, Courtesy Lights, Compass/Lighted Mirror, Horn, Lighted Visor, Door Locks, Power Mirrors, Rear Glass Release, Audible Warning System
What should a GM ignition coil reading be?
The reading should be between .70 and 1.7 ohms. If it is outside that range, the coil is defective. Place a lead from the ohmmeter on either side terminal and one in the center high tension terminal. Read the ohms off the meter.
What should I do if my fuse melts on my Caprice?
The wiring circuits in your vehicle are protected from short circuits by a combination of fuses, circuit breakers, and fusible thermal links in the wiring itself. This greatly reduces the chance of fires caused by electrical problems. Look at the silver-colored band inside the fuse. If the band is broken or melted, replace the fuse.
What should I do if my ignition coil is outside the range?
Reattach the wires to the positive and negative side terminals followed by the retaining nuts for both sides. Tighten the nuts with a wrench. Plug the coil wire back into the high tension terminal in the center of the coil. If the coil is outside the ranges here, do not reinstall it. Instead, replace the coil right away.