Why does my Kranks Commodore have no spark?
Took it for a spin and ran rough. Put it back up and found the oil pressure sender was leaking and pissed oil all over the right engine mount and stuffed it. Replaced both and it was smoother but still kranky under load back up she goes.
How to get no spark or injector pulse?
Checked codes and got crank cam and O2 sensor. Replaced the crank sensor and the engine control relay with an OEX unit from Ashdown’s. If I bypass the fuel pump relay I get constant fuel flow but no spark or pulse. Someone please tell me I am not up for an ECU BCM and FOB package
How to know if your engine has no spark?
First Confirm Your Engine Has No Spark. 1 Disable the fuel system by removing the fuel pump fuse or relay. 2 Insert a spark plug tester into the plug boot and ground it on a piece of metal on the engine. 3 Finally, Have someone crank the engine and watch for spark.
How to check for spark in a VL Commodore?
Id suggest checking for spark too VL’s are known to have spark issues that kills them. Remove a lead, stick a screwdriver inside, position the screwdriver 5mm from a metal part of the engine and confirm you see a spark arcing between the 2 while cranking the engine.
Checked codes and got crank cam and O2 sensor. Replaced the crank sensor and the engine control relay with an OEX unit from Ashdown’s. If I bypass the fuel pump relay I get constant fuel flow but no spark or pulse. Someone please tell me I am not up for an ECU BCM and FOB package
Took it for a spin and ran rough. Put it back up and found the oil pressure sender was leaking and pissed oil all over the right engine mount and stuffed it. Replaced both and it was smoother but still kranky under load back up she goes.
How to change injectors in a VL Commodore?
Turn the ingnition switch to the “ON” position and ensure the LED’s remain lit. 4.) Carefully turn the diagnostic mode selector fully clockwise. 5.) Start the engine and allow it to idle. By starting the engine the starter signal circuit is activated and the red and green LED’s may begin to flash.