How can I find a wholesale distributor for my product?
If you do an online search, don’t just search for general wholesalers or distributors. Be sure to include keywords from your products or niche. Try product names, model numbers and brand names.
How do you mark the location of a distributor?
Make the same marks that you made on your old distributor on your new distributor. In other words, mark your old distributor’s rotor position inside the housing of your new distributor and mark the location on the outside of the distributor that lines up with your engine’s mounting point.
Do you need to remove the distributor cap?
While performing maintenance on your ignition system, you should remove the distributor cap in order to clean the contacts or replace the cap. But when you put a distributor cap back on, it must be done a certain way. Become familiar with your distributor before you take it apart.
Can a bad distributor cap cause a misfire?
The throttle body fuel injectors do not spray gasoline. The following are usually the most common symptoms of a bad spark plug wires, or a bad distributor cap and rotor on this type of GM distributor mounted ignition control module: The car (or truck, or mini-van, or van) starts and runs, but with a misfire.
How can I tell if my distributor cap is OK?
If your distributor caps are ok, you’ll have to check the contact points on the distributor. This should be done after inspecting the condenser. This part of the car shouldn’t be opened or damaged, as it can mean that a wire lead is broken and the electrical connection is not functioning properly.
Why is the distributor cap set at 15 degrees?
This adjustable rotor allows the tuner to move the tip relative to its stock location to line up the rotor with the terminal on the cap. We chose 15 degrees because that’s a typical initial timing setting.
How is the distributor cap connected to the spark plugs?
Picture the distributor cap as a crown that a king would wear. The points of the crown are where the distributor is connected to the spark plugs by spark plug wires. Each point connects to one spark plug, and each spark plug goes to one cylinder in your engine.
Can you replace the distributor cap and rotor?
To replace the distributor itself, yes, but not just the cap and rotor. Triedaq July 6, 2016, 2:41am #3 The distributor cap and rotor can only fit one way onto the distributor. If the distributor remained in the engine, there is no problem.