How do you replace spark plugs in a Hyundai Sonata?
How to Replace Spark Plugs in a Hyundai Sonata. Turn off the Sonata engine and allow it to cool. This normally takes about 30 minutes. Raise the hood and locate the spark plug cables along the side of the engine. Spark plug cables are normally 1/4 to 1/2 inch thick and plug directly into the engine. Grasp the cable by its boot.
Where are the spark plug cables on a Hyundai Santa Fe?
Most Hyundai Santa Fe engines’ cables are on the right and left sides of the engine about a quarter of the way down. Some of the engines’ cables run along the front and back of the engine instead. Remove and clean the boot or the cable. Grab the spark plug cable by the boot,…
What kind of spark plugs do Hyundais use?
The original spark plugs installed on Hyundai equipped with the four-cylinder engine are NGK, or Denso iridium coated spark plugs. Below we have listed two highly rated spark plugs that will fit Hyundai vehicles.
Where are the spark plug wires on a Hyundai XG350?
Refer to the Hyundai car service manual for the factory recommended parts and parts numbers needed. Open the hood and locate the spark plug wires on the Hyundai XG350. The wires run across the top of the engine and are either blue or black (depending on the manufacturer of the last spark plug wires that were installed).
When to change the spark plug on a Hyundai?
If your Hyundai check engine light is on or you have over 100,000 miles on your Hyundai, it may be time to change the spark plugs. Park, your Hyundai in a safe area, set the parking brakes, and allow the engine to cool down.
What kind of spark plugs does a Hyundai Elantra use?
The original spark plugs installed on Hyundai equipped with the four-cylinder engine are NGK, or Denso iridium coated spark plugs. Below we have listed two highly rated spark plugs that will fit Hyundai vehicles. Denso Iridium Long Life Spark Plugs for Hyundai Elantra SX9164 NGK Iridium IX Plug Spark Plugs for Hyundai Elantra
What’s the best way to remove a spark plug?
Remove spark plug. Blow dirt away from the spark plug recess before you remove the spark plugs. Use the spark plug removal tool, ratchet, and a 3/8″ extension to remove the spark plugs from the engine. Rotate counterclockwise to remove the spark plug.