How do you change the spark plug on a Citroen C3?
The instructions on the plug box say to tighten the plug 1/2 to 2/3 of a turn after the point the plug has engaged (when it’s finger tight), but this may differ for other brands of plug. Once all plugs are changed refit the coil pack, wiring and hose. Turn the engine over and check all is well. Job done.
How to change the spark plug on a car?
Lube the Spark Plug Boot and Button It Up 1 Apply a thin coating of dielectric grease around the inside of the spark plug boot before reinstalling the coil. 2 Reinstall the ignition coil, hold-down bolt and coil electrical connector. 3 Reinstall the air cleaner and vanity cover and fire it up.
What kind of strut does a Citroen Xsara use?
The familiar range of PSA powertrains drove the front wheels of a seemingly conventionally designed chassis. At the front was a standard MacPherson strut layout with anti-roll bar, while the rear used the PSA Peugeot-Citroën fully independent trailing arm/torsion bar set up, which was first introduced on the estate of the Peugeot 305 .
How do you change the glow plug on a Honda Accord?
Using a deep socket or combination wrench, remove the glow plug from the cylinder head. Screw the glow plug reamer into the glow plug opening all the way in then out. Install the new glow plug. Reconnect the connector to the glow plug terminal.
The instructions on the plug box say to tighten the plug 1/2 to 2/3 of a turn after the point the plug has engaged (when it’s finger tight), but this may differ for other brands of plug. Once all plugs are changed refit the coil pack, wiring and hose. Turn the engine over and check all is well. Job done.
Where are the spark plug wires in the correct order?
If you still don’t understand, you can also visit your car dealer or service centre. You can always request them to explain the process of putting the spark plug wires into the correct order. As you know, the rotor located underneath the distributor cap. It can spin clockwise or anti-clockwise.
Where is the distributor cap on a spark plug?
Start by removing the distributor cap. This is a big round part where all four spark plug wires are connected. The distributor cap is located in the front or at the top of the engine. It is held in place tightly by two latches. Remove the latches using a screwdriver. At this point, use a marker to make two lines.
What happens if you cross the spark plug wires?
The role of the spark is to ignite the mixture and cause combustion. If the vehicle has crossing spark plug wires, the spark plugs get the heat at the wrong time. This means that the process of combustion does not happen, and the engine won’t run.