How do you put a tension belt on a coolant drive?
Insert the pry bar above the alternator pulley. Apply gentle pressure upwards so that it adds tension to the drive belt. Once the drive belt is moved into its desired tension, tighten the adjustment bolt to lock the belt in place. Then, torque the adjustment bolt to the manufacturer’s specifications.
Where do I find the serpentine belt on my car?
To access the serpentine belt, you will need to open the hood of the vehicle. The hood release can usually be found near the door on the driver’s side of the vehicle. With the hood released, you will also need to release the safety latch located at the front of the vehicle.
How can I increase the tension on my serpentine belt?
Increase the tension on the belt. If your vehicle does not have an auto tensioner, insert a pry bar or piece of wood between the alternator and the engine. Run the belt over the alternator pulley, then use the bar to pry the alternator away from the engine and increase the tension on the belt.
How do you remove a serpentine belt from a battery?
Use the appropriate sized wrench or socket to loosen the nut holding the black ground cable on the negative terminal of the battery. Slide the cable off of the terminal and tuck it to the side of the battery. You will not need to disconnect the positive terminal. Locate the serpentine belt.
What kind of pulley does a serpentine belt use?
Determine if there is a belt tensioner pulley. Depending on the application, your serpentine belt will either have tension placed on it using a movable bracket or an auto tensioner pulley. This pulley uses an internal spring to apply consistent pressure to the belt at all times.
To access the serpentine belt, you will need to open the hood of the vehicle. The hood release can usually be found near the door on the driver’s side of the vehicle. With the hood released, you will also need to release the safety latch located at the front of the vehicle.
Where is the tensioner on a serpentine belt?
When using a serpentine belt system, all of the accessories that are being driven are fixed, they do not adjust in order to tension the belt. In this system, there is typically one spring-loaded tensioner located somewhere in the system that the belt travels over.
Use the appropriate sized wrench or socket to loosen the nut holding the black ground cable on the negative terminal of the battery. Slide the cable off of the terminal and tuck it to the side of the battery. You will not need to disconnect the positive terminal. Locate the serpentine belt.
Where does the P / S Pump go in a serpentine belt?
Water pump pulley installed. Before you mount the P/S pump to the driver’s side main bracket, you must place the spacer as shown in the photo group below. Be sure to run the pump mounting bolts through the pump and spacer, and then into the main bracket.