Do you have to tighten the belt on a Suzuki Vitara?
As the belt ages, it stretches, and when it stretches too much you must loosen the tensioner pulley to tighten the belt or to replace the belt. The Vitara does not have an automatic belt tensioner built into the tensioner pulley. You must manually adjust the pulley, but before you can do that you must loosen it.
Where is the pulley on a Suzuki Grand Vitara?
The Suzuki Grand Vitara uses a single serpentine drive belt to run all of the engine’s accessories, including the radiator fan. The belt uses the power from the crankshaft pulley, located in the lower front of the engine.
How do you remove a serpentine belt from a car?
Pull the belt off of the pulleys. With the tension relieved from the belt, pull it off of the pulley that has been placing tension on it, then remove it from the around the rest of the pulleys on the engine. If the belt is severely damaged, be sure to remove any parts that may have come off of it as well.
Where is the tensioner on a Suzuki Grand Vitara?
You must manually adjust the pulley, but before you can do that you must loosen it. Locate the Grand Vitara’s tensioner pulley on the front of the engine block between the power steering pump and the crankshaft pulley. The tensioner has a hex-head bolt going through the center of it, and it does not have any accessories attached to it.
As the belt ages, it stretches, and when it stretches too much you must loosen the tensioner pulley to tighten the belt or to replace the belt. The Vitara does not have an automatic belt tensioner built into the tensioner pulley. You must manually adjust the pulley, but before you can do that you must loosen it.
The Suzuki Grand Vitara uses a single serpentine drive belt to run all of the engine’s accessories, including the radiator fan. The belt uses the power from the crankshaft pulley, located in the lower front of the engine.
What’s the best way to replace a serpentine belt?
Auto tensioners have either a hole that will fit a half inch drive ratchet, or a bolt you can use a socket to apply pressure to. Insert the wrench or place the socket over the bolt on the tensioner and twist it away from the belt to relieve the tension on it.
You must manually adjust the pulley, but before you can do that you must loosen it. Locate the Grand Vitara’s tensioner pulley on the front of the engine block between the power steering pump and the crankshaft pulley. The tensioner has a hex-head bolt going through the center of it, and it does not have any accessories attached to it.