What do I need to replace serpentine belt on Dodge Ram?
Make sure the shielding around your wheels and engine is attached for full serpentine belt life. The procedure for the 5.7 Hemi engine differs from the 3.7/4.7 engines. For owners with the 5.7 liter engine, you will need a 3/8″ ratchet (preferably long-handled).
How to replace the serpentine belt in a Jeep Grand Cherokee?
Rotate the belt tensioner pulley, using the wrench, to and relieve tension on the belt. Slip off the old belt and slowly release the tensioner pulley. Use your belt routing diagram to put the new belt onto all of the pulleys. Pay close attention to the water pump pulley, as incorrect routing can cause the water pump to run backwards and overheat.
How do you tighten a serpentine belt on a car?
If your vehicle does not have an auto tensioner, insert a pry bar or piece of wood between the alternator and the engine. Run the belt over the alternator pulley, then use the bar to pry the alternator away from the engine and increase the tension on the belt. Tighten the bolts again as you apply tension.
How do you change power steering belt tension?
On these models, change the tension on the belt by loosening the two power steering bolts on the side of the power steering pump, then turn the adjustment bolt below the pump counter-clockwise to release tension on the belt. Follow the above steps for replacement using this alternate system.
How is the serpentine belt in a Chev?
Pictures, diagrams of serpentine belt routing. 2.4L. Belt Diagram 3.4 DOHC Cam Engine Drive Belt Diag… 3.5L Engine Serpentine Belt in Chev… 4.2L Inline Six Cylinder Engine Bel… 3800 V6 Belt Routing Picture and Ro…
What kind of belt does a Dodge Ram use?
Since the Ram uses the serpentine belt to rotate the water pump, when the belt breaks you are forced to come to a stop. This article applies to the Dodge Ram (2002-2008). The serpentine belt is made of a rubber compound and is grooved for optimal friction with the accessory pulleys.
Make sure the shielding around your wheels and engine is attached for full serpentine belt life. The procedure for the 5.7 Hemi engine differs from the 3.7/4.7 engines. For owners with the 5.7 liter engine, you will need a 3/8″ ratchet (preferably long-handled).
How to change the serpentine belt on a 6.7 Cummins?
To start, pop the hood and locate where the belt sits. It should be easy to find as it snakes around several components. Next, release the tensioner from the A/C pulley, then remove the airbox. Undo one bolt and release the tensioner. Rotate it clockwise to move it out of the path.
When do I need to replace my serpentine belt?
When to Replace Your Serpentine Belt. If you notice that your belt has damage or wear, but it’s still working and not making noise, should you still replace it? In short, yes. It’s better to regularly replace your serpentine belt when it shows signs of wear or damage rather than let it break when you’re on the road.
Since the Ram uses the serpentine belt to rotate the water pump, when the belt breaks you are forced to come to a stop. This article applies to the Dodge Ram (2002-2008). The serpentine belt is made of a rubber compound and is grooved for optimal friction with the accessory pulleys.