How do you take a serpentine belt off a car?
(There is often an idler pulley in the system which looks rather similar to the tensioner pulley — but it is not a tensioning device, not spring loaded). After letting the engine cool thoroughly, use one of the tools mentioned below to pivot the tensioner pulley to take the tension off the belt.
How is the tension set on a serpentine belt?
Depending on the application, your serpentine belt will either have tension placed on it using a movable bracket or an auto tensioner pulley. This pulley uses an internal spring to apply consistent pressure to the belt at all times. If your vehicle does not have a tensioner pulley, the alternator bracket is likely how tension is set on the belt.
How do you remove a belt from an auto tensioner?
Hold the tension from the belt, and slip the belt off the auto tensioner pulley to remove the belt and pulley system. Slowly release the tension to avoid damage or injury, and then remove the tool from the belt auto tensioner.
How much does it cost to replace a serpentine belt?
A serpentine belt costs 20$ to 50$ and labor costs 40$ to 100$. You can expect a total cost of 60$ to 150$ for a serpentine replacement. However, what needs to be mentioned is that usually, when you replace the serpentine belt, you often want to replace some pulleys and the automatic tensioner if your car is equipped with one.
How often should you replace the serpentine belt?
Serpentine belts can last for years and might only need to be changed once or twice over the life of the vehicle. The recommended industry standard is to inspect your belt at 60,000 miles for wear & tear and replace if necessary, and replace every 90,000 miles regardless of the appearance in order to reduce the chances of a breakdown.
How easy is it to change the serpentine belt?
How to Replace Your Serpentine Belt Note the placement of belt. Serpentine belts have that name for a reason. Loosen and unthread the belt. Before removing the belt, you’ll need to release the tensioner, which automatically keeps the belt taut while you’re driving. Check for damage. After removing the belt, inspect it for signs of damage. Install the new belt.
How do you change the serpentine belt?
How to Change a Serpentine Belt Step 1 – Get Out Your Cars Diagram Step 2 – Turn Off Your Car and Keep It on Idle Step 3 – Pop the Hood Step 4 – Note How the Belt Functions Step 5 – Relieve the Tensioner Pressure Step 6 – Slide the Belt Off the Pulley Step 7 – Remove the Motor Mount Step 8 – Replace the Belt Step 9 – Clean Up
How do I put on serpentine belt?
Snap a long-handled ratchet or a serpentine belt tool into the square 1/2-in.-drive or 3/8-in.-drive opening. Or use a socket on the hex-shaped protruding nut. Slowly rotate the tensioner arm as far as it will turn. Then release the tension.