Why is my shower pull cord not working?
Sometimes a pull cord won’t pull because the wiring is pressing against the switch inside. Before changing the pull cord, try loosening the two screws slightly. If that frees the mechanism, then turn off the power, open the box and arrange the wires more tidily so that they fit inside the enclosure better.
Where to put choke lever on pocket bike?
In certain weather conditions, you may put the choke lever in the middle or lower position to help make it easier to start. Starting may require several tries when the bike is still new. After break-in, the bike will start up with only one or two pull procedures.
What’s the best way to turn off a pocket bike?
Once you are done riding the bike and plan to turn it off, turn the gas valve in the horizontal position, closing the gas to the bike (as shown in image4 with the yellow arrow, the gas valve in the HORIZONTAL position). This stops the gas from flowing around the bike, which in turn prevents the carburetor from flooding in the future.
How to start a mini chopper pocket bike?
Put the choke lever in the closed position (as shown in image2 with red arrow, the lever in the UP position). Pull the start cord out slowly until it reaches its maximum distance, allowing the gas to flow into the bike. Repeat 2 times. On the 3 rd attempt, pull the cord quickly with the intention of turning the bike on.
How do you tighten the tension on a pocket bike?
Simply slip off the rubber dust boot / sleeve and loosen the tension ring by hand (no tools necessary) and turn clockwise until you get your desired speed. Then tighten the tension ring and you are ready to go.
In certain weather conditions, you may put the choke lever in the middle or lower position to help make it easier to start. Starting may require several tries when the bike is still new. After break-in, the bike will start up with only one or two pull procedures.
Once you are done riding the bike and plan to turn it off, turn the gas valve in the horizontal position, closing the gas to the bike (as shown in image4 with the yellow arrow, the gas valve in the HORIZONTAL position). This stops the gas from flowing around the bike, which in turn prevents the carburetor from flooding in the future.
Put the choke lever in the closed position (as shown in image2 with red arrow, the lever in the UP position). Pull the start cord out slowly until it reaches its maximum distance, allowing the gas to flow into the bike. Repeat 2 times. On the 3 rd attempt, pull the cord quickly with the intention of turning the bike on.
How to properly start a pocket bike with the pull starter?
Just add pure gasoline into the gas tank. There is a separate oil pan with dipstick located on the front of the engine. Like an automobile, please periodically check the oil level. SAE 10w40 is used when it comes time for an oil change (approximately every 1000 miles or when dirty). How do I properly start the bike with the Pull Starter?