Where is the governor Located on my scooter?
Your scooter’s rev limiter prevents its engine from transferring all of its energy to the drive belt. It is located in your scooter’s drive belt or variator system on the left side of the scooter.
How can I make my scooter go faster?
Making a derestricted scooter go faster
- Use a larger carburetor and/or larger jets.
- Use a more free flowing air filter.
- Use a more free flowing exhaust system.
- Install a cylinder head with larger/more valves.
What is a governor on a scooter?
Mechanical governors are any devices that regulate the operating speed of a machine, specifically an engine. Removing your scooter’s governor washer from the variator system removes the operating speed regulations for your scooter’s engine, allowing your scooter to travel faster.
What happens when you remove the governor from a scooter?
Removing this washer from the variator ostensibly removes the scooter’s governor. Removing your scooter’s governor washer from the variator system removes the operating speed regulations for your scooter’s engine, allowing your scooter to travel faster. Remove the kick stand.
How to remove the governor for a 50cc Honda Metro scooter?
Removing the governor of your 50 cc Honda Metro scooter will certainly increase its speed, and it may even enable it to travel fast enough that you may need to reregister the vehicle as a larger class motorcycle. Pull out the pin attaching the kickstart to the variator case of your Honda Metro.
How do you remove Governor from Honda variator?
Pull the governing washer off of the front pulley rod. This washer acts as a governor for your scooter, restricting the speed at which your variator’s belt can run. Replace the front pulley wheel and tighten the bolt holding it in place. You will need to secure the wheel with your strap wrench to sufficiently tighten the bolt.
How to make your 49 / 50cc Scooter faster?
If you want to get a speed pack for your scooter, click here. If you want to learn more. Check Out this 4 Part Video Series. Click Here to Check it Out. You’ll learn the details on how to make your 49/50cc scooter 5-10 MPH faster.
How do you remove the governor on a scooter?
Take the faceplate off of the front pulley wheel to access the governor washer. Pull the governor washer off of the pulley rod by hand.
Pull the governing washer off of the front pulley rod. This washer acts as a governor for your scooter, restricting the speed at which your variator’s belt can run. Replace the front pulley wheel and tighten the bolt holding it in place. You will need to secure the wheel with your strap wrench to sufficiently tighten the bolt.
How do you remove the variator from a scooter?
Unscrew and remove the two bolts holding the plastic cover of the intake box if your scooter has one. Some scooters do not have this covering, in which case you can directly access the variator box from the outside of the scooter. Unscrew and remove the bolts of the variator case lid. There are six bolts around the edge of the box.
How do you remove the kick stand from a scooter?
Remove the kick stand. Pull the pin attaching the scooter to the variator box up and out and then pull the kick stand off of the box. Set the kick stand aside. Unscrew and remove the two bolts holding the plastic cover of the intake box if your scooter has one.