Where is the power switch on a fog light?
1 pre installed power switch. When the coil of the relay is energized 12v from the high beam switch to terminal 86 ground on terminal 85 the normally closed contacts open interrupting 12v to the fog. 1 wiring diagram and users instruction.
Where are the relay terminals on a fog light?
Use the following procedure. Power 12v to the fogs lights passes through the normally closed contacts of the relay terminals 30 and 87a. Connect the end of the. 1 full wiring kit handles up to 130 watt. Turn on the low beam headlamps.
How to draw a wiring diagram for a fog light?
1 wiring diagram and users instruction. This is a general wiring diagram for automotive applications. 12v universal wiring harness kit relay fuse switch. Fog lights off with high beams on relay wiring diagram. Draw a diagram on plain white paper with wire gauge noted and colors identified.
What do you need to know about the wiring on a Saturn?
These Saturn Wiring information / Aftermarket Autostart/Alarm Technical Wiring Diagrams are very useful, if not required, for the installation of alarms, autostart / alarms, remote starts, doorlock info and any other aftermarket installation that would require you to know the / Wire Information / Wiring Information of your Saturn
When to turn off fog lights in unlit area?
That reflected light is for the most part, going to come from city lighting sources. If you’re in an unlit area, on an undivided road, flip your fog lights off for oncoming traffic. You don’t want to blind the other driver. The etiquette rules for fog lights are the same as for bright-high beams.
Where is the relay wire for a fog light?
Connect one BLACK lead to the vehicle ground and to the relay terminal labeled 86. Connect the YELLOW wire to the yellow switch wire terminal and to the relay terminal labeled 85. Test the operation of the lamps as follows: Re-connect the battery.
Where to place a fog lamp on the wall?
For Fog Lamps, adjust them so the top of the light beam is 4 inches (102mm) below the center line mark on the wall. For Driving Lamps, adjust them so the bright spot of the beam pattern is on the centerline mark on the wall.