Can you replace the stereo on a Saturn Ion?
Upgrading or replacing the factory stereo in your Saturn Ion is difficult if you can’t determine how to remove it. Modern vehicles have complicated dash panels and inlets that get in the way of stereo removal. You can use the same technique to remove the dash stereo of any model year Saturn Ion.
When does the ignition switch need to be set?
The ignition switch needs to be set to the accessory position before you can release it from the ignition module. The “accessory” position is before the starter is engaged, and would normally let you run the vehicle’s electronics without the engine running (when the battery is connected).
How do you disconnect the battery from a Saturn?
Use the pliers to disconnect the vehicle’s battery. To prevent electric shock, disconnect the battery anytime you work with a vehicle’s wiring. Remove the two air vents on the dash panel above the Saturn radio. Grab the vents, then twist and pull them to remove. Slide your fingers into the vent holes and release the upper clips to the dash panel.
What’s the Accessory position on an ignition switch?
Insert the key and turn it to the “accessory” position. The ignition switch needs to be set to the accessory position before you can release it from the ignition module. The “accessory” position is before the starter is engaged, and would normally let you run the vehicle’s electronics without the engine running (when the battery is connected).
How does the ignition switch work on a Saturn?
Saturn vehicles use a transponder inside the ignition key to prevent unauthorized engine starting. There is a component inside the dash and linked to the ignition switch that sends a signal to the starter motor allowing the vehicle to start.
What should I do if my Saturn ignition is not working?
Turn the ignition key and try to start the engine. If the battery is known to be fully charged, the Saturn should start. If there is an error in the ignition switch, you will not hear the typical faint “click” when you initially turn the ignition key to the “III” position to crank the engine.
Where is the starter fuse on a Saturn?
Open the fuse panel under the steering column by turning the knob on the fuse panel counterclockwise and pulling down on the cover. Locate the fuse for the starter in the fuse panel using the fuse diagram on the underside of the fuse panel cover.
What to do if you have ignition switch problem?
If you are experiencing problems with your ignition key or switch, you may need a simple key reset or you could have a faulty ignition switch that needs to be replaced. Open the fuse panel under the steering column by turning the knob on the fuse panel counterclockwise and pulling down on the cover.
How does the PassLock work on a Saturn Ion 3?
The 2003 Saturn Ion 3 is equipped with the Passlock anti-theft system. The system disables the ignition if it detects that starting the car is attempted with an invalid key. When the Passlock system is activated, the security light flashes on the instrument panel. The engine cannot be started until the system resets.
How do you remove air vents from Saturn?
Remove the two air vents on the dash panel above the Saturn radio. Grab the vents, then twist and pull them to remove. Slide your fingers into the vent holes and release the upper clips to the dash panel. Pull the top part of the panel off, then pull the bottom clips out to completely remove the panel.
How do you remove a radio from a Saturn Ion?
Pull the top part of the panel off, then pull the bottom clips out to completely remove the panel. Use the screwdriver to remove the two screws that mount the radio. Pull the radio unit out and disconnect the module from the rear. These instructions can also be used on the specialty Red-Line Saturn Ion vehicle.
Remove the two air vents on the dash panel above the Saturn radio. Grab the vents, then twist and pull them to remove. Slide your fingers into the vent holes and release the upper clips to the dash panel. Pull the top part of the panel off, then pull the bottom clips out to completely remove the panel.
Use the pliers to disconnect the vehicle’s battery. To prevent electric shock, disconnect the battery anytime you work with a vehicle’s wiring. Remove the two air vents on the dash panel above the Saturn radio. Grab the vents, then twist and pull them to remove. Slide your fingers into the vent holes and release the upper clips to the dash panel.
Where are the air vents on a Saturn radio?
Remove the two air vents on the dash panel above the Saturn radio. Grab the vents, then twist and pull them to remove. Slide your fingers into the vent holes and release the upper clips to the dash panel.
How do you remove a radio from a car?
Slide your fingers into the vent holes and release the upper clips to the dash panel. Pull the top part of the panel off, then pull the bottom clips out to completely remove the panel. Use the screwdriver to remove the two screws that mount the radio. Pull the radio unit out and disconnect the module from the rear.