Why Saturn won t start?
While there are a variety of reasons your Saturn Ion won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter.
Why is my fuel pump not working on my Saturn s?
This is caused mainly by overdrawing from the 12v socket, or high power aftermarket accessories drawing from the same circuit. There will be melted plastic around the fuse. The radio, chime module, dome light, 12v socket, and fuel pump are on this circuit. You will probably know about it when the fuel pump stops working.
When does a Saturn’s series engine fail?
The aftermarket replacements have a quality problem; best bet is to find a low mileage junkyard replacement or order the OE part (~$70). Not hugely common, but still a recurring failure. They usually fail when the engine is hot. You’ll be driving along, and suddenly the engine dies, and won’t restart until it cools.
What kind of spark plugs do Saturn’s series use?
Most copper plugs fit this description. Narrow fine wire electrodes almost always cause problems, usually a p0300 and running like the car needs new plugs. The easiest thing to do here is just use the OE spark plugs, they’re inexpensive and just work. NGK BKR5ESA-11 (DOHC) and BKR4ESA-11 (SOHC). These have a higher than normal failure rate.
Why are my coil springs broken on my Saturn s?
-Broken coil springs in 3rd generation (00-02) cars. If you’re doing struts, replace the springs. OE junkyard replacements from a gen-1 or gen-2 car are your best bet. This is caused mainly by overdrawing from the 12v socket, or high power aftermarket accessories drawing from the same circuit.
The aftermarket replacements have a quality problem; best bet is to find a low mileage junkyard replacement or order the OE part (~$70). Not hugely common, but still a recurring failure. They usually fail when the engine is hot. You’ll be driving along, and suddenly the engine dies, and won’t restart until it cools.
This is caused mainly by overdrawing from the 12v socket, or high power aftermarket accessories drawing from the same circuit. There will be melted plastic around the fuse. The radio, chime module, dome light, 12v socket, and fuel pump are on this circuit. You will probably know about it when the fuel pump stops working.
Most copper plugs fit this description. Narrow fine wire electrodes almost always cause problems, usually a p0300 and running like the car needs new plugs. The easiest thing to do here is just use the OE spark plugs, they’re inexpensive and just work. NGK BKR5ESA-11 (DOHC) and BKR4ESA-11 (SOHC). These have a higher than normal failure rate.
-Broken coil springs in 3rd generation (00-02) cars. If you’re doing struts, replace the springs. OE junkyard replacements from a gen-1 or gen-2 car are your best bet. This is caused mainly by overdrawing from the 12v socket, or high power aftermarket accessories drawing from the same circuit.