Do you have to calibrate the H-gated shifter?
Before first use the H-gated shifter must be calibrated to work properly. The calibration has to be done only once and will be saved in the firmware but it will be deleted after a firmware update. Please do it again after the wheel is updated/flashed.
How do you move the shifter in a Clubsport?
Move the shifter into first gear position and press “Start Button” 8. Move the shifter into second gear position and press “Start Button” 9. Move the shifter into third gear position and press “Start Button” 10. Move the shifter into fourth gear position and press “Start Button” 11.
Where is the H-gated shifter on a CSW rim?
1. Connect the H-gated shifter to “shifter port 1” of your wheel 2. Power the wheel on 3. Wait until auto-calibration and boot sequence are finished 4. Press “Tuning Button” + “Start Button” simulanously (the position of these buttons may vary depending on the CSW rim you are using!) 5.
What should the thread pitch be on a shifter?
It is an M12x1.5 20mm screw thread to mount various shifter knobs. Here, 1.5 mm is the thread pitch. NOTE: Some aftermarket shifter knobs may have a thread pitch of 1.75 mm. Therefore, it is important to be sure of the thread pitch which must be 1.5 mm.
Before first use the H-gated shifter must be calibrated to work properly. The calibration has to be done only once and will be saved in the firmware but it will be deleted after a firmware update. Please do it again after the wheel is updated/flashed.
Move the shifter into first gear position and press “Start Button” 8. Move the shifter into second gear position and press “Start Button” 9. Move the shifter into third gear position and press “Start Button” 10. Move the shifter into fourth gear position and press “Start Button” 11.
Where is the shifter in a manual transmission car?
Today most manual-transmission cars are equipped with a floor shifter. In general, prior to World War II, most vehicles had a shifter mounted in the top cover of the transmission.
1. Connect the H-gated shifter to “shifter port 1” of your wheel 2. Power the wheel on 3. Wait until auto-calibration and boot sequence are finished 4. Press “Tuning Button” + “Start Button” simulanously (the position of these buttons may vary depending on the CSW rim you are using!) 5.