How do I reattach the ignition switch on my car?
Remove any bolts or press locking tabs to release the switch. Insert and align the new switch before bolting it in or fastening the tabs. Reattach the electrical connector. If you have removed the key cylinder in order to access the switch, you must reinstall this component.
What’s the Accessory position on an ignition switch?
Insert the key and turn it to the “accessory” position. The ignition switch needs to be set to the accessory position before you can release it from the ignition module. The “accessory” position is before the starter is engaged, and would normally let you run the vehicle’s electronics without the engine running (when the battery is connected).
What to do if your key is stuck in the ignition switch?
The key may be stuck in the ignition switch, but that shouldn’t stop you from turning it. If you don’t have a key, you will need to force the module to turn using a flathead screwdriver. Press the release pin inside the hole on the ignition module with a screwdriver.
Can you use code diysave10 on a car ignition switch?
10% OFF $75. Use Code: DIYSAVE10 Online Ship-to-Home Orders Only The ignition switch makes it possible to start the engine in a vehicle. A malfunctioning or failed ignition switch may prevent a car or truck from starting, cause the engine to stall or result in electrical problems.
Where is the ignition switch on a car?
There are actually two parts that might be referred to as an ignition switch: the ignition lock cylinder that the key is inserted into to start the car, and the actual electronic ignition switch (located behind the lock cylinder) that provides power to the starter motor.
The key may be stuck in the ignition switch, but that shouldn’t stop you from turning it. If you don’t have a key, you will need to force the module to turn using a flathead screwdriver. Press the release pin inside the hole on the ignition module with a screwdriver.
What should I do if I need to replace my ignition switch?
Reconnect the cable to the negative (-) terminal on the battery, then insert the key into the ignition and turn it to start the vehicle. The vehicle should start without any issue. If it doesn’t, remove the ignition switch and reinstall it. Shut the engine off (if it starts) and disconnect the battery again.
How do you replace the ignition switch on a Saturn s?
The exact procedure varies by vehicle, but but for some vehicles replacing an ignition switch requires disassembling the plastic steering column covers. A mechanic provides a video demonstration of replacing an ignition switch on a Saturn S series.