Where are the clutch cables on a Saturn FSM?
The cables are attached to the shifter tower by small clips that should just slide off. To disconnect them from the bell housing just pull back slightly and then lift through the slot. (There is an excellent diagram in the Saturn FSM if you have one.)
Can you remove the slave cylinder from a Saturn clutch?
Remove the clutch slave cylinder. Do NOT disconnect the hydraulic lines. The Saturn clutch hydraulics are a closed system and are not meant to be serviced. If you accidentally pull one of these lines you will need to buy new hydraulics from Saturn. Do NOT step on the clutch with the slave cylinder removed.
How tall is the clutch socket on a Saturn?
– 30mm Tall Socket – Some sort of engine support – Saturn shop manual with torque specifications Much easier if you have a hoist to run the car up and down.
– 30mm Tall Socket – Some sort of engine support – Saturn shop manual with torque specifications Much easier if you have a hoist to run the car up and down.
Do you need a Haynes Manual to replace a Saturn clutch?
These instructions are a conglomeration of several other how-to documents, Saturn FSMs, shop manuals, online postings and other sources of information. These instructions should not be considered a stand alone document and should be used in conjuction with an FSM, Haynes, or Chiltons manual.
Remove the clutch slave cylinder. Do NOT disconnect the hydraulic lines. The Saturn clutch hydraulics are a closed system and are not meant to be serviced. If you accidentally pull one of these lines you will need to buy new hydraulics from Saturn. Do NOT step on the clutch with the slave cylinder removed.
The cables are attached to the shifter tower by small clips that should just slide off. To disconnect them from the bell housing just pull back slightly and then lift through the slot. (There is an excellent diagram in the Saturn FSM if you have one.)