Where is the reservoir on a Saturn Vue?
However, if your VUE is an older model–before 2008–then you’ll find the reservoir in the back right corner. Find the negative cable connected to the battery and disconnect it. Check if your Saturn VUE has air bags. If it does, wait at least a minute and a half before doing any work. Detach the hose and connector from the washer pump.
Where is the hood release on a Saturn Vue?
Work on your Saturn VUE in your driveway, if it’s relatively flat. Back in, so you have easy access to the hood. Put your SUV in park, turn it off, remove the keys, put on the emergency brake and locate the hood release, which is on the left side of the steering wheel under the instrument panel.
How do you replace a windshield washer reservoir?
Install the new windshield washer reservoir, by first pushing the pump into it. Then, put the two retainers and the air induction assembly back where they belong. Next, put the reservoir assembly in your Saturn VUE, redo the screws, replace the seals and connect the electrical lead and the hose. Reconnect the negative battery cable.
How do you remove a washer pump from an SUV?
Detach the hose and connector from the washer pump. Using a screwdriver, unscrew the two lower screws and the upper screw that attach the reservoir to your SUV. Then, lift out the reservoir and toss the seals in the trash. You should always replace the seals and not reuse the old ones.
When to replace the windshield washer reservoir in a Saturn Vue?
How to Replace the Windshield Washer Reservoir in a Saturn VUE. The Saturn VUE was the top selling SUV until the summer of 2008. No matter what year your VUE is, you want to maintain it and have it looking new. One way to do this is to make sure your windshield is always sparkling.
What to do if your Saturn Vue has air bags?
Check if your Saturn VUE has air bags. If it does, wait at least a minute and a half before doing any work. Detach the hose and connector from the washer pump. Using a screwdriver, unscrew the two lower screws and the upper screw that attach the reservoir to your SUV. Then, lift out the reservoir and toss the seals in the trash.
Install the new windshield washer reservoir, by first pushing the pump into it. Then, put the two retainers and the air induction assembly back where they belong. Next, put the reservoir assembly in your Saturn VUE, redo the screws, replace the seals and connect the electrical lead and the hose. Reconnect the negative battery cable.
Work on your Saturn VUE in your driveway, if it’s relatively flat. Back in, so you have easy access to the hood. Put your SUV in park, turn it off, remove the keys, put on the emergency brake and locate the hood release, which is on the left side of the steering wheel under the instrument panel.
What to do if your windshield washer is plugged?
Disconnect the tubing there and try the washer again. If fluid squirts out, you know the nozzles are plugged. Clean the nozzles by pushing a small pin in to loosen any debris, then blow the clog back down the hose and out the end that you disconnected.
What to do if your Saturn Vue Reservoir is leaking?
Fill the new reservoir with fluid and test it to make sure you put everything back exactly as you found it and everything is working properly. Check for a repairable crack in your Saturn VUE’s reservoir by pouring some fluid in to find the leak. You may be able to repair the reservoir, rather than replace it, if the crack is small enough.