How to remove and replace a thermostat in a Saturn?
Disconnect the hoses from the housing. Using your socket set, remove the bolts holding the thermostat housing in place. Put the tip of your paint scraper between the housing and the engine block and pry up gently to remove the housing. Once the housing is free, remove the gasket that was between the housing and the block.
How do you remove the thermostat on a Kia Sorento?
Do not remove the thermostat, even if the engine tends to overheat. 1. Drain engine coolant so its level is below thermostat. 2. Remove the radiator lower hose (A). 3. Remove water inlet fitting (A), gasket (B) and thermostat (C). 4. Install in the reverse order of removal. Install the thermostat with the jiggle valve upward. 5.
How to replace a MerCruiser Alpha thermostat step by step?
How to Replace a MerCruiser Alpha Thermostat Step 1. Open the engine cover of your MerCruiser to access the engine. Locate the thermostat housing. It mounts to the… Step 2. Remove the two bolts securing the housing to the engine block. Pull the cover off the thermostat housing. Step 3. Make note …
Where does the thermostat housing meet the radiator?
The thermostat housing is right where the radiator hose meets the engine housing. It looks like half of a metal baseball. When the thermostat becomes stuck, it is reasonable to simply replace it. Also, when the thermostat housing is removed, the housing gasket should be replaced even if you’re just checking it.
Disconnect the hoses from the housing. Using your socket set, remove the bolts holding the thermostat housing in place. Put the tip of your paint scraper between the housing and the engine block and pry up gently to remove the housing. Once the housing is free, remove the gasket that was between the housing and the block.
Who is the owner of the 2004 Saturn Vue?
2004 Saturn VUE Owner ManualM SATURN, the SATURN Emblem, and the name VUE are registered trademarks of Saturn Corporation. GENERAL MOTORS and GM are registered trademarks of General Motors Corportation. This manual includes the latest information at the time it was printed.
How do you lower the seat in a Saturn Vue?
•Move the seat forward or rearward by moving the control forward or rearward. •Raise or lower the seat by sliding the control up or down. •Raise or lower the front portion of the seat by sliding the front of the control up or down. •Raise or lower the rear portion of the seat by sliding the rear of the control up or down. 1-3 Manual Lumbar
Where is the filler cap on a Saturn radiator?
Place the bucket under the driver’s side corner of the radiator beneath the radiator draincock (located on the bottom of the radiator). Remove the filler cap from the radiator.
How does coolant sensor work on Saturn Vue?
A sensor checks the coolant temperature and signals the vehicle’s computer that a richer gas mixture is needed to start the engine in cold weather. Check if this sensor is functioning and the condition of the coolant. Coolant becomes acidic after three years and will prove destructive to the engine.
What are the body parts of a Saturn Vue?
For the Saturn VUE body parts, employed are A/C condensers, front bumpers, front fenders, hoods, hubcaps, front lights, mirrors, radiators and wheels.
How to change the oil on a Saturn Vue?
If the oil has been changed and the Change Oil indicator remains lit, the indicator needs to be reset manually. First, turn the ignition key to the ‘RUN’ position, engine OFF. Second, press and release the gas pedal 3 times in 5 seconds or less until you see the indicator flash.
What is the coolant system on a Saturn SL1?
The Saturn SL1 is a fuel-efficient car produced by General Motors. The high revolution engine in this car makes the coolant system a crucial part of the vehicle. The coolant system is controlled by a thermostat, which is set to open once the engine gets hot.
When do you need to replace the radiator thermostat?
At this point, the thermostat will release enough coolant to flow through the engine and cool it down. Once the thermostat starts to stick, it will need to be replaced. Draining the radiator will be required to prevent spilling the coolant during the replacement process.
How do you remove a thermostat from a car?
Tighten the splash guard back onto the bottom of the car with the socket wrench. Do not over-tighten the bolts as they are made of a hard plastic and could strip out. Raise the car up and remove the jack stands. Lower the car to the ground with the jack. Locate the thermostat by tracing the lower radiator hose to the engine.
Fortunately, a thermostat in a Saturn is both inexpensive and relatively easy to replace. 1. Park the car on a level surface, turn off the engine and let the engine cool a minimum of 2 hours before beginning to remove and replace the thermostat.
What happens if the thermostat stops working on a 1999 Pontiac Grand Am Se?
If the thermostat in your 1999 Pontiac Grand Am SE stops working, you run the risk of the engine overheating and warping. The repair bill to have an engine machined can be several thousand dollars. When you notice the temperature gauge going higher than normal, it is time to change the thermostat.
Where is the thermostat housing on a Pontiac?
Locate the thermostat housing by following the top radiator hose from the radiator to the Pontiac’s intake. The hose connects to the metal thermostat housing. Remove the radiator hose from the thermostat housing.
When to check fuses on a Saturn SL?
Electrical components such as your map light, radio, heated seats, high beams, power windows all have fuses and if they suddenly stop working, chances are you have a fuse that has blown out. If your SL is experiencing electrical problems, you should always check the fuses first, because they are relatively easy to check and cheap to change.
Where is the thermostat housing on a Saturn?
Locate the thermostat housing. The housing will be on the top of the engine; you can find it easily no matter what model year Saturn you have, by following the main hose coming from the radiator to the engine block. That hose will end at the thermostat housing and there will be one or two houses coming off the housing as well.
Where is the thermostat located on a car?
Locate the thermostat by tracing the lower radiator hose to the engine. This can be reached easier from the top of the engine compartment. Unscrew the two bolts at the end of the radiator hose with a socket wrench. Pull the hose and the thermostat away from the engine. Loosen the hose from the thermostat housing with a flat head screwdriver.
How do you remove the radiator thermostat from a car?
Unscrew the two bolts at the end of the radiator hose with a socket wrench. Pull the hose and the thermostat away from the engine. Loosen the hose from the thermostat housing with a flat head screwdriver.