How to reset Check Engine light saturn ion 2006?

How to reset Check Engine light saturn ion 2006?

How do I reset the check engine light on my Saturn?

  1. Let it go off by itself.
  2. Turn your ignition on and off several times in a row.
  3. Disconnect your battery and reconnect it.
  4. Buy an OBD II scanner (they’re relatively inexpensive) and follow the instructions (it’s pretty easy)

How much is a Starter for a Saturn Ion 2007?

2007 Saturn Ion Starter – from $169.99+ | AutoZone.com.

How do you turn off the engine on a Saturn Ion?

Turn the key to the off position without removing it and back to “Run” for 10 more minutes. Turn the key off again and back to “Run” for 10 minutes a third. Turn the key off and then attempt to start the engine.

How to reset a security system on a Saturn Ion?

To reset the system, get in the car and shut the door. Turn the key on to the “Run” position without cranking the engine. Leave the key there for exactly 10 minutes. Turn the key to the off position without removing it and back to “Run” for 10 more minutes.

How does the PASSKey System on a Saturn Ion work?

The PASSKEY system uses an exciter coil located inside the key lock tumbler that detects the correct key being inserted and turned to start the car. When the correct key is turned in the cylinder it sends a signal to the computer which will then allow the fuel injectors to function.

Is there an anti theft system on a Saturn Ion?

But most of today’s vehicles come equipped with an anti-theft system that is integrated into the vehicle’s computers. The 2007 Saturn Ion is one of them. The Ion uses two systems that provide different functions, but for the same purpose: to prevent theft.

What are the problems with my 2004 ion2?

Need some confirmation. Having intermittent starting problems with my 2004 ION2. Insert key, turn on, lights come on but no turnover. Sit a few minutes, turn on, tries to start but dies as if no gas, or get a turnover and that’s it. Sit another couple of minutes, turn on, lights, no turnover.

Where is the ignition switch on a Saturn?

The problem was due to the original ignition switch which is a $50 part from Saturn. The ignition switch is located on the back end of the ignition lock. The ignition switch sends a code that is generated in the ignition lock to the body control module (BCM). It is a part of the Passlock2 system on the 2004 Saturn.

What does the PassLock system on a Saturn do?

The Passlock system is intended to prevent a worn (worn keys use to be about to start any of the earlier model Saturns without any security system) or incorrect key from starting the car. If the proper code is not sent then the BCM will shut down the car for up to 10 minutes.

Posted In Q&A