Does a 2008 saturn astra have a timing belt or a timing chain?
The 2008 Saturn Astra use timing belt or chain. I assume this is a question. The 1.8 L Ecotec 2HO motor uses a timing belt. It appears the belt is good for 100K miles.
Does 2008 saturn aura have timing belt or chain?
Replacement Timing Chain Kit – for 2008 Saturn Aura 2.4L 145Cu.
Can a timing chain be replaced with an engine?
Published on Feb 25, 2018 Showing stretched timing chains and evidencing that the timing chain can be replaced with the engine in the vehicle on a 2012 Chevrolet Traverse 3.6 AWD Category Autos & Vehicles Show moreShow less Loading… AutoplayWhen autoplay is enabled, a suggested video will automatically play next. Up next
Where is the hole in the timing chain?
The triangular marks should be aligned. The painted link on the right intermediate shaft should be aligned with the hole in the rear gear. The left camshafts will be aligned as shown when in stage two timing position. (Fig. 6)
Where to install en 48383-3 timing chain?
EN 48383-3 should be installed on the right bank, or bank 1. The triangular marks should be aligned. The painted link on the right intermediate shaft should be aligned with the hole in the rear gear.
How to set the timing on a V6 engine?
To set the timing on a high feature V6 engine, start with the engine in stage one position with tool EN 46105-1, Camshaft Locking Tool, or EN 48383-1, Camshaft Retaining Tool, on the left bank, or bank 2. The circular timing marks on the camshafts should be aligned as shown. (Fig.
Published on Feb 25, 2018 Showing stretched timing chains and evidencing that the timing chain can be replaced with the engine in the vehicle on a 2012 Chevrolet Traverse 3.6 AWD Category Autos & Vehicles Show moreShow less Loading… AutoplayWhen autoplay is enabled, a suggested video will automatically play next. Up next
The triangular marks should be aligned. The painted link on the right intermediate shaft should be aligned with the hole in the rear gear. The left camshafts will be aligned as shown when in stage two timing position. (Fig. 6)
EN 48383-3 should be installed on the right bank, or bank 1. The triangular marks should be aligned. The painted link on the right intermediate shaft should be aligned with the hole in the rear gear.
To set the timing on a high feature V6 engine, start with the engine in stage one position with tool EN 46105-1, Camshaft Locking Tool, or EN 48383-1, Camshaft Retaining Tool, on the left bank, or bank 2. The circular timing marks on the camshafts should be aligned as shown. (Fig.