How do you remove the dash pad on a Mopar?
Also loosen two 7/16-inch nuts holding the steering column in place. It will drop down about 1/2-inch to provide a little more room to remove the gauge cluster. Remove the Phillips head screws from the metal panel under the front lip of the dash pad. Gently pull the panel down. Bag and label these for reinstallation.
How do you remove air conditioning from Dash?
If your car is equipped with air conditioning, as this vehicle is, you must drop the under dash ducting by removing three large Phillips head screws. Detach the ducting to each side vent and center duct and remove it all from the car. Next remove the metal trim panel under the steering column, again three Phillips screws.
How do you remove the passenger side dash?
Pull the bottom of the passenger-side dash off by hand, by pulling up and then out. Go to the driver’s door and locate the eight screws that go along the side of the driver-side dash. Remove the screws and keep them somewhere safe. Go to the passenger side and remove the eight screws that hold the dash in on that side.
How do you remove the radio from the dash?
Unplug the radio harness and antenna cable from the radio and pull it out of the dash. Leave all wiring under the dash. Next locate and remove four 3/8-inch nuts securing the heater controls to the rear of the pad. I prefer to leave these controls intact so I remove them from the pad and simply let the assembly hang.
How do you remove the dash from a Mopar?
Working from under the dash, find and remove all the speed nuts retaining the dash to the metal frame at the front and rear. A good light will be handy here. Remove four 7/16-inch bolts, one on each side of the defroster vents using a swivel socket to clear the windshield glass.
Pull the bottom of the passenger-side dash off by hand, by pulling up and then out. Go to the driver’s door and locate the eight screws that go along the side of the driver-side dash. Remove the screws and keep them somewhere safe. Go to the passenger side and remove the eight screws that hold the dash in on that side.
How do you replace the dash on a corvette?
Once you get the console out, unplug both the radio (or Nav unit) and the HVAC (heater) control, and remove them. This is what you will then have: It looks pretty daunting, but those connectors are easy to put back in place, as are the radio and HVAC control.
Do you need to remove the dash on a Pontiac?
Removing the dash is sometimes necessary if you want access to the parts under the dash, such as the radio or the gauges. The plastic on the dash of the Pontiac car can be brittle, so care needs to be taken when removing the dash.