What does code P0702 mean?
A P0702 trouble code means that one of the transmission’s sensors, solenoids, or switches has sent a signal to the PCM of the detection of a reading that doesn’t match the manufacturer’s specifications. In addition, the PCM can store a P0702 trouble code when other transmission-related trouble codes are stored.
What does it mean when your transmission says p0720?
You are experiencing transmission problems. You press the gas pedal, and the engine RPMs go up to 4000 or even higher and you are limited to a max speed of about 30 MPH. The check engine light (CEL) comes on. You scan the car using an OBD-II code reader, and you get fault codes such as P0715, P0720, P0700.
What does fault code p0702 mean on Jeep Grand Cherokee?
This fault is very common, it means that transmission solenoids are not getting enough power. With this code there can be 2 reasons – gearbox plug adapter or weak battery. About gearbox plug adapter you can look at tip 4. If adapter is fine, then your car has a weak battery and you need to change it.
When to set the trouble code p0700?
The TCM monitors the sensors and actuators relating to transmission control and communicates with the Engine Control Module (ECM) to inform it of any possible issues with the automatic transmission control module. The trouble code P0700 is set whenever the TCM detects a malfunction with the transmission controls.
What does code p1875 mean on Allison Transmission?
ALLISON AT Code (DTC) P1875 Transmission Automatic Hall Effect Sensor Power Circuit Short To Battery / 4WD Low Switch Circuit Electrical ALLISON AT Code (DTC) P1876 Transmission Transfer Case 2-Wheel Drive Solenoid Circuit Failure
What does p0702 mean in engine control module?
P0702 Meaning The code is triggered by the Engine Control Module (ECM) when there is a code stored in the Transmission Control Module (TCM)
When is the diagnostic trouble code p0717 detected?
The Diagnostic Trouble Code (DTC) P0717 is detected when TCM or ECM receives no signal from the sensor. Need more information on how to fix the P0717 CHEVROLET code?
What does p0717 input turbine speed sensor circuit no signal trouble code?
If you have a P0717 Input Turbine Speed Sensor Circuit No Signal trouble code, this post will help you understand what it is and how to fix it. The computer wants to know if the transmission is working properly. So it reads the speed of the input shaft and compares it to the speed of the output shaft.
What does DTC p0702 stand for in ECM?
DTC P0702 refers to a general transmission control system electrical fault, but not to a specific fault, such as a solenoid open circuit, for example. On finding DTC P0702 stored in ECM memory, further diagnosis will be required to determine the nature of the fault. What are the common causes of code P0702 ?