What causes the p0727 OBD-II trouble code?

More often than not, the problems that trigger the P0727 code are caused by either a defective transmission output speed sensor or a faulty engine input speed sensor. However, there could be other reasons too, like:

What should I do if my crank sensor is bad?

So if your car is a 1996 or newer model, the most common method of diagnosing a bad crank sensor is to plug in a code reader, read the fault code, and see if the crank sensor is listed as the culprit. However, if you have a pre-OBD-II car, you’ll have to diagnose it yourself.

What kind of sensor is on the crankshaft?

Some cars employ two separate crank sensors—one that senses only TDC and another that measures the actual rotation. In this case, the first is usually called the crankshaft reference sensor, and the second may be called the crank angle or crank speed sensor. The other type of sensor is the Hall Effect sensor.

What does the switching signal on a crankshaft mean?

Well, because the term ‘Switching Signal’ is just a descriptive name for the turning on and off of the primary current passing thru’ the Ignition Coil. In conclusion, this turning on and off only happens after the Ignition Module (or Fuel Injection Computer) receives the Crankshaft Position Sensor Signal.

What is the code for a bad crankshaft position sensor?

A diagnostic scan tool will show a code between P0335 and P0338. The check engine light doesn’t always come on, though, so you could be experiencing any of the above symptoms for some time before you see the warning light. There are a number of different problems that can cause similar symptoms to a crankshaft position sensor problem.

When to replace the crankshaft position sensor ( CKP )?

If your reading is not close to the recommended resistance, then you should replace the sensor. Another way to test the crankshaft position sensor (CKP) is with a multimeter. You do this by checking the output voltage with the engine cranking. You will need an assistant to do this.

Can a bad crankshaft sensor cause a check engine light?

Another issue of a potential problem with the crankshaft position sensor is an illuminated Check Engine Light. If the computer detects a problem with the crankshaft position sensor’s signal, it will activate the Check Engine Light to alert the driver of the problem. A Check Engine Light can also be set off by a wide variety of other issues.

What does the p0727 code on the ECM mean?

The P0727 Codes is triggered when the TCM receives no signal from the ECM. P0727 Possible Symptoms. P0727 Meaning. The Engine Control Module (ECM) monitors the engine speed through the Crankshaft Position (CKP) sensor with the engine running, and send signal to the Transmission Control Module (TCM).

What are the symptoms of a bad transmission speed sensor?

Symptoms of a Bad or Failing Transmission Speed Sensor. 1 1. Harsh or Improper Shifting. Without a valid speed signal from these sensors, the PCM will not be able to correctly control the shifting of gears 2 2. Cruise Control Does Not Work. 3 3. Check Engine Light Comes On.

Can a bad speed sensor affect shift timing?

Harsh or improper shifting. Without a valid speed signal from these sensors, the PCM will not be able to correctly control the shifting of gears within the transmission. This may cause the transmission to shift roughly or more quickly than normal. It’s also common that a problem with these sensors can impact the shift timing,…

How much does it cost to diagnose Saturn code p0727?

The cost of diagnosing the P0727 SATURN code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour. When is the P0727 SATURN code detected? The P0727 Codes is triggered when the TCM receives no signal from the ECM.

Navigation