How to make a motorcycle crank but no start?
Grounding plugs to block wont give you a spark. youll have to make a set of dummy plugs by taping them together. turn spark plugs opposite of eachother, metal to metal and tape with electrical tape. Then plug the boots back on and check again. Click to expand… I don’t understand this at all.
Can a bad crankshaft sensor cause the engine to stall?
If the crankshaft position sensor or its wiring have any issues, it can cause the crankshaft signal to be cut off while the engine is running, which can cause the engine to stall. This is usually a symptom of a wiring problem, however a bad crankshaft position sensor can also produce this symptom.
What causes a Harley Davidson to not start?
Open up the nose cone end and see if it is just really dirty in there which can happen if the seal is leaking oil. If not, check that the signal wires from the ignition wire to the coil are not corroded at the coil, or damaged where they come out of the nose cone.
Can a Dyna Super Glide crank but not start?
Discussion in ‘ Electrical ‘ started by 92chrisdyna, Aug 16, 2010 . 92 dyna super glide my bike cranks but wont start I have power to the coil and no spark I replaced the coil and nothing where do I go from here I am new to harleys and new to the forum and love some help from you guys thanks
What does no crank no start car mean?
Mechanics refer to this as a no crank no start condition. Of course, the number one reason for an engine not the crank on any car would be a problem with the battery. Since classic car owners are familiar with how to treat a battery during long-term storage we’ll just touch on this briefly and then move on.
Where does the 12 V go in a no crank car?
With the ignition key in the on position, there should be power on the heavy gauge red wire and a strong ground on the black wire. When the ignition key is pushed to the crank position you should have an additional 12 V going into the relay and 12 V comes out on the wire that runs to the starter solenoid.
Grounding plugs to block wont give you a spark. youll have to make a set of dummy plugs by taping them together. turn spark plugs opposite of eachother, metal to metal and tape with electrical tape. Then plug the boots back on and check again. Click to expand… I don’t understand this at all.
What happens if you have a classic car that won’t start?
One of the downsides of owning a classic car is they sit for long periods of time. As we head towards the automobile with the key in hand, we often wonder if she will fire up or not. Professional mechanics divide a no start condition into two main categories. There is the scenario where the engine spins over nicely but refuses to start.