How do I turn off my OnStar Chevy Cruze?
Completely Disable OnStar On Your Chevy Cruze
- So you want to completely disable OnStar?
- First, find the cars fuse compartment.
- Open the fuse compartment.
- If you have a car that’s not a Cruze, there’ll be a diagram on the back of the fuse panel cover.
- All you have to do is remove the fuse.
Is there a way to disable the OnStar module?
As soon as you can see and access the OnStar module box, you can stop pulling the panel out of place. Step 6: Remove the three connectors on the OnStar module box. Press the tab down on the cord end that connects with the module box port and pull the connector right out.
How do you remove an OnStar antenna from a car?
Remove the nut and any screws holding the antenna in place. Pull up the antenna from the roof of the car. Some plugs will come up with it, so unplug them to remove the fin completely. Re-attach the headliner and replace all the screws to finish the job. After removing the OnStar antenna, there will be a small hole in the roof of your truck.
Where do I go to Activate my OnStar account?
Visit the Onstar website and select the option to Manage Account. This is located on the left-hand side of the OnStar landing page under the option to “Buy Minutes or Data” and above the choice to “Activate Pre-Owned Vehicle.”
What happens if I cancel my OnStar subscription?
The benefits of OnStar can be outweighed by its cost or intrusiveness. For most people, simply cancelling the OnStar subscription is enough. This does not prevent OnStar from being able to retrieve data from your vehicle, however.
Why do I need to disable my OnStar account?
While many people find the OnStar service to be very useful, there are some reasons you may wish to disable it, including a change in budget or its vulnerability to hacking. Step 1: Visit the Onstar website. Visit the Onstar website and select the option to Manage Account.
How do you remove the OnStar module from a vehicle?
1. Remove Onstar Module from vehicle. 2. Remove the 6 T10 screws from the bottom of the Onstar Module. 3. Pull up on the main board to separate it from the antenna board. 4. Remove the Male/Male connector that connects the main board to the antenna board. 5. Drop the main board back in without the Male/Male connector and reinstall the screws. 6.
Where are the screws to deactivate OnStar?
If your vehicle does not have a cargo net in the trunk, the four screws you need to remove should be located in the corners of your trunk. After removing the screws, pull the sill plate up to lift it out of the trunk. Set it and the screws aside in a safe spot while you continue working.
What should I do if my OnStar light goes off?
Pressing the OnStar button beneath the rearview mirror should now result in dead air. If the OnStar light was previously on, it should now be off. You should also check your other vehicle systems to make sure that none of them were affected. Turn on all lights, radios, and other electric features.