Why is my fuel pump not working on my Saturn s?
This is caused mainly by overdrawing from the 12v socket, or high power aftermarket accessories drawing from the same circuit. There will be melted plastic around the fuse. The radio, chime module, dome light, 12v socket, and fuel pump are on this circuit. You will probably know about it when the fuel pump stops working.
When does a Saturn’s series engine fail?
The aftermarket replacements have a quality problem; best bet is to find a low mileage junkyard replacement or order the OE part (~$70). Not hugely common, but still a recurring failure. They usually fail when the engine is hot. You’ll be driving along, and suddenly the engine dies, and won’t restart until it cools.
What to do if your crankshaft sensor is not working?
Issues with the crankshaft sensor can quickly lead to problems that affect the drivability of the vehicle. For this reason, if you suspect your crankshaft position sensor has an issue, have the vehicle inspected by a professional technician right away. They will be able to diagnose your car and replace your crankshaft position sensor if necessary.
How does the crankshaft position sensor work in a car?
It monitors the position and rotational speed of the crankshaft and sends the information to the engine control unit so it can make appropriate adjustments based on operating conditions.
What happens when you replace the crankshaft sensor?
Q: Replaced crankshaft sensor and now car won’t start. Even tried putting old one back and still won’t start. No problem starting bef Was told my crankshaft sensor needed replacing. Car was running bad. Shop ran codes and came up with crankshaft sensor. I replaced it with a new one now car won’t start.
What happens when crankshaft position sensor ( CKP ) fails?
If the sensor (CKP) has failed completely, then the computer won’t send any fuel to the injectors. Consequently, Leaving you unable to start the car. A Crankshaft Position Sensor (CKP) Failure may cause the check engine light on your dashboard to come on.
Can a bad crankshaft sensor cause a cylinder to misfire?
Should you feel or hear a brief stutter in the engine, it may be a sign of misfiring cylinders from a bad crankshaft position sensor. A failing crankshaft position sensor cannot provide the right information about piston positioning in the engine, causing a cylinder to misfire.
Why did my car not start after I replaced the sensor?
If you disconnected the battery before replacing the sensor, this could be one cause of the vehicle not to start. A new crankshaft sensor should not have prevented the vehicle from starting.
Are there any problems with the Saturn’s series?
Saturn experimented with making these out of plastic, it was a huge failure. ALL of them failed, if you still own one of these cars and it hasn’t been replaced, it has failed. Symptoms include hard starting, rough idle, temperature gauge not working, awful fuel economy, poor performance, and stumbling, among many other things.
What kind of spark plugs do Saturn’s series use?
Most copper plugs fit this description. Narrow fine wire electrodes almost always cause problems, usually a p0300 and running like the car needs new plugs. The easiest thing to do here is just use the OE spark plugs, they’re inexpensive and just work. NGK BKR5ESA-11 (DOHC) and BKR4ESA-11 (SOHC). These have a higher than normal failure rate.
What causes a Saturn’s to slam into reverse?
This causes the car to “slam” into reverse and/or harsh upshifts, depending on which is worn. It will eventually destroy the line pressure solenoid, which will make for very hard upshifts. If left for a while, it will knock the input shaft nut loose, further worsening the condition of the shifts.
This is caused mainly by overdrawing from the 12v socket, or high power aftermarket accessories drawing from the same circuit. There will be melted plastic around the fuse. The radio, chime module, dome light, 12v socket, and fuel pump are on this circuit. You will probably know about it when the fuel pump stops working.
Saturn experimented with making these out of plastic, it was a huge failure. ALL of them failed, if you still own one of these cars and it hasn’t been replaced, it has failed. Symptoms include hard starting, rough idle, temperature gauge not working, awful fuel economy, poor performance, and stumbling, among many other things.
This causes the car to “slam” into reverse and/or harsh upshifts, depending on which is worn. It will eventually destroy the line pressure solenoid, which will make for very hard upshifts. If left for a while, it will knock the input shaft nut loose, further worsening the condition of the shifts.
Most copper plugs fit this description. Narrow fine wire electrodes almost always cause problems, usually a p0300 and running like the car needs new plugs. The easiest thing to do here is just use the OE spark plugs, they’re inexpensive and just work. NGK BKR5ESA-11 (DOHC) and BKR4ESA-11 (SOHC). These have a higher than normal failure rate.
How to know if your engine has no spark?
First Confirm Your Engine Has No Spark. 1 Disable the fuel system by removing the fuel pump fuse or relay. 2 Insert a spark plug tester into the plug boot and ground it on a piece of metal on the engine. 3 Finally, Have someone crank the engine and watch for spark.
What should the electrode diameter be on a Saturn s?
Without getting into too much detail, the basic requirement is the diameter of the electrode should be roughly the width of the ground. Most copper plugs fit this description. Narrow fine wire electrodes almost always cause problems, usually a p0300 and running like the car needs new plugs.
Why is the fuel gauge on my car not working?
Some fuel gauges have an analog display while others have a digital or liquid crystal display. Electronic and software malfunctions may cause the fuel gauge in your automobile to inaccurately measure or display the amount of fuel remaining in the gas tank. If this happens, reset your fuel gauge.
Why does my Saturn car not start up?
There are many reasons why a Saturn car may not start. By checking a few simple things under the hood, the vehicle owner may be able to get to the root of the problem. If the simple things check out, the problem may be more complicated and may require a diagnostic opinion.
The aftermarket replacements have a quality problem; best bet is to find a low mileage junkyard replacement or order the OE part (~$70). Not hugely common, but still a recurring failure. They usually fail when the engine is hot. You’ll be driving along, and suddenly the engine dies, and won’t restart until it cools.
Why are my coil springs broken on my Saturn s?
-Broken coil springs in 3rd generation (00-02) cars. If you’re doing struts, replace the springs. OE junkyard replacements from a gen-1 or gen-2 car are your best bet. This is caused mainly by overdrawing from the 12v socket, or high power aftermarket accessories drawing from the same circuit.
-Broken coil springs in 3rd generation (00-02) cars. If you’re doing struts, replace the springs. OE junkyard replacements from a gen-1 or gen-2 car are your best bet. This is caused mainly by overdrawing from the 12v socket, or high power aftermarket accessories drawing from the same circuit.
Where can I buy Saturn parts for my car?
RockAuto ships auto parts and body parts from over 300 manufacturers to customers’ doors worldwide, all at warehouse prices. Easy to use parts catalog. SATURN Parts | RockAuto
What are the symptoms of a Saturn’s series failure?
ALL of them failed, if you still own one of these cars and it hasn’t been replaced, it has failed. Symptoms include hard starting, rough idle, temperature gauge not working, awful fuel economy, poor performance, and stumbling, among many other things. This sensor has at least something to do with almost everything the computer does.
What was the biggest problem with Saturn cars?
This one is universal, and the single biggest cause of problems with these cars. Saturn experimented with making these out of plastic, it was a huge failure. ALL of them failed, if you still own one of these cars and it hasn’t been replaced, it has failed.
Why does my Saturn’s have a toaster head?
Some people run a 60-40 antifreeze-water mix as a preventative measure. The key symptom is massive oil contamination in the coolant, to the point where it has the consistency of a chocolate milkshake. The head is toast and the coolant system will need to be flushed thoroughly. This is only a problem with the SOHC engine.
ALL of them failed, if you still own one of these cars and it hasn’t been replaced, it has failed. Symptoms include hard starting, rough idle, temperature gauge not working, awful fuel economy, poor performance, and stumbling, among many other things. This sensor has at least something to do with almost everything the computer does.
This one is universal, and the single biggest cause of problems with these cars. Saturn experimented with making these out of plastic, it was a huge failure. ALL of them failed, if you still own one of these cars and it hasn’t been replaced, it has failed.
Some people run a 60-40 antifreeze-water mix as a preventative measure. The key symptom is massive oil contamination in the coolant, to the point where it has the consistency of a chocolate milkshake. The head is toast and the coolant system will need to be flushed thoroughly. This is only a problem with the SOHC engine.
https://www.youtube.com/watch?v=zYmi1pADZNU