How to replace the rear wheel bearing hub?
To do this, you’ll have to stick the large bolt through the big hole of the hub and rest it against the backing plate and not the inner part of the hub. Then, insert the washer on the other end of the bolt behind the hub, following with the nut. Screw the nut alaway up to the back of the hub so its tight.
How do you change the wheel bearing on a GMC Sierra?
Remove the axle nut in the center of the hub — on four-wheel-drive models only — using a 36 mm socket and ratchet. Unplug ABS sensor wiring from the back of the hub assembly. Remove the three 15 mm hub and bearing assembly bolts from the back of the steering knuckle. Slide the hub assembly out of the steering knuckle.
Do you need to replace whole hub assembly?
Just get the complete hub assembly and some anti-sieze to apply liberally. They are cheap enough to replace the whole assemblies you don’t need to bother with it. So I got a question!!!
When do wheel bearings need to be replaced on a Porsche?
This article applies to the Porsche 928, Porsche 993, and Porsche 997 (1978-2012). One of the more common parts that requires replacement on Porsches (with higher mileage) are wheel hub bearings. Most that attempt to do the job themselves become very frustrated because removing everything can be a giant pain.
How do you replace a hub bearing?
Part 1 of 1: Replacing the hub bearing. Step 1: Loosen the nuts. Loosen the lug nuts from the wheel which the bearing is going to be replaced. Step 2: Raise and secure the vehicle. Raise the vehicle and secure it on jack stands, and then remove the wheel.
Should I replace wheel hub bearing?
As a rule, sealed wheel bearings and hubs should have no play or roughness when a wheel is spun by hand. If a wheel bearing feels loose, or has play that exceeds specifications when measured with a dial indicator placed against the hub, it is worn out and needs to be replaced without delay.
How do you replace a wheel hub assembly?
Step 1: Prepare your work area. Step 2: Loosen the lug nuts. Step 3: Jack the vehicle up and use jack stands. Step 4: Remove the old wheel hub assembly. Step 5: Install the new wheel hub assembly and brake parts. Step 6: Reinstall the wheels. Step 7: Jack the vehicle back off of the jack stands. Step 8: Torque the wheels.
How much does it cost to replace wheel bearings on a car?
If the bearing is sealed, it can lead to more work such as replacing the hub as well; however, a permanently sealed bearing means they can last longer, oftentimes, as long as the car. For the parts alone, wheel bearings can cost anywhere from $20 to as much as $200.