How do you program a key fob for a 2003 Saturn Ion?
IMPORTANT:
- Install a scan tool.
- Turn ON the ignition with the engine OFF.
- Select Remote Function Actuation.
- Select Special Functions.
- Select Program Key Fobs.
- Select the number of key fobs to be programmed.
How to program a Saturn Vue keyless entry remote?
For best results, stand approximately five feet from the Vue. Hold down the “Lock” and “Unlock” buttons on the keyless entry remote for at least seven seconds. Release the “Lock” and “Unlock” buttons after you hear the Vue’s power locks perform a locking or unlocking cycle. The keyless entry remote is now synchronized to your Saturn Vue.
How do you program a Saturn key fob?
Repeat the programming sequence–by holding the lock and unlock buttons–on your next remote. Do this within one minute and wait for the locks to cycle again to indicate successful programming. Repeat again with any additional remotes, up to four, and be sure to do it within a minute and wait for the locks after every remote.
How to reset ignition PassLock on a 2003 Saturn Ion 3?
If the Passlock system does not automatically reset, it can be reset manually. Turn the ignition key to the “Start” position as if you are starting the engine. Turn the ignition key to the “Run” position after two to three seconds. Leave the key in this position for 10 minutes.
How can I reprogram my Remote key fob?
Make sure that the ignition is not in the radio mode, and do not start the engine. Press the lock button on the remote key With the key in the ‘On’ position, press the fob’s lock button and turn the key back to the ‘Off’ position. Repeat this process at least three times, ending the cycle with the key in the ‘On’ position.
For best results, stand approximately five feet from the Vue. Hold down the “Lock” and “Unlock” buttons on the keyless entry remote for at least seven seconds. Release the “Lock” and “Unlock” buttons after you hear the Vue’s power locks perform a locking or unlocking cycle. The keyless entry remote is now synchronized to your Saturn Vue.
Repeat the programming sequence–by holding the lock and unlock buttons–on your next remote. Do this within one minute and wait for the locks to cycle again to indicate successful programming. Repeat again with any additional remotes, up to four, and be sure to do it within a minute and wait for the locks after every remote.
How long does it take to program a Saturn Remote?
Release the buttons once the locks cycle and that remote will be successfully programmed. Repeat the programming sequence–by holding the lock and unlock buttons–on your next remote. Do this within one minute and wait for the locks to cycle again to indicate successful programming.
Where is the data port on a Saturn?
Insert your key into the ignition and leave the key in the “Off” position. Locate the car’s data port on beneath the dash board panel on the driver’s side. Notice the eight data terminals on each side of the port and connect the jumper wire to the 8 and 4 terminals, which are eighth and fourth from the left side of the port on the top side.