What kind of vibration does a Saab 93 TTiD 180 have?

What kind of vibration does a Saab 93 TTiD 180 have?

Saab 93 ttid 180 aero estate 61 plate 58,000miles. Have recently noticed a heavy vibration under heavy acceleration at low revs in high gear, normaly 5th or 6th. It doesn’t do it when accelerating hard in the lower gears. If I lift off slightly it goes away, and will also disapear when once the revs are up.

Why is the swirl flap on my Saab not working?

Also check the inlet manifold to see if the swirl flap control arm has detached itself. Saab 93 ttid 180 aero estate 61 plate 58,000miles. Have recently noticed a heavy vibration under heavy acceleration at low revs in high gear, normaly 5th or 6th. It doesn’t do it when accelerating hard in the lower gears.

How can I tell if my Saab engine is leaking?

To properly diagnose this condition perform a cold (after an overnight stay is best) compression and leak down test. As an example, an engine with a 150-175 psi hot cranking compression reading may only show 75 to 90 psi when cold.

Why does my Saab engine have acrid smoke?

The smoke will be very acrid and will make your eyes sting and water. This indicates engine is burning engine oil and can be caused by the following faults.

Saab 93 ttid 180 aero estate 61 plate 58,000miles. Have recently noticed a heavy vibration under heavy acceleration at low revs in high gear, normaly 5th or 6th. It doesn’t do it when accelerating hard in the lower gears. If I lift off slightly it goes away, and will also disapear when once the revs are up.

Also check the inlet manifold to see if the swirl flap control arm has detached itself. Saab 93 ttid 180 aero estate 61 plate 58,000miles. Have recently noticed a heavy vibration under heavy acceleration at low revs in high gear, normaly 5th or 6th. It doesn’t do it when accelerating hard in the lower gears.

To properly diagnose this condition perform a cold (after an overnight stay is best) compression and leak down test. As an example, an engine with a 150-175 psi hot cranking compression reading may only show 75 to 90 psi when cold.

Why is my Saab diesel engine not working?

This is generally due to air/fuel ratio imbalance. Either the fuel system is delivering too much fuel, or there is not enough air. A few things that can be at fault are: Faulty injectors (injectors need attention/ cleaning periodically.)

What’s the problem with a 6 speed Saab?

Here’s the solution to a pretty common problem on Saab cars that have a 6-speed manual gearbox. Is your gear stick seized in position, or maybe it won’t return to neutral? Stiff to change gear? Difficult to find gears? Gear change vague and unable to select correct gear?

What to do if your Saab has a problem?

You need to check that the EGR valve is operating fully. Also check the inlet manifold to see if the swirl flap control arm has detached itself. Saab 93 ttid 180 aero estate 61 plate 58,000miles. Have recently noticed a heavy vibration under heavy acceleration at low revs in high gear, normaly 5th or 6th.

Why does my Saab 95 sport Tid splutter?

Hi I have a Saab 95 sport tid 150 bhp and it splutters between one and a half and 2 1/2 thousand revs have run a cleaner through it still the same, some times it sounds like the dump valve. You need to check that the EGR valve is operating fully.

You need to check that the EGR valve is operating fully. Also check the inlet manifold to see if the swirl flap control arm has detached itself. Saab 93 ttid 180 aero estate 61 plate 58,000miles. Have recently noticed a heavy vibration under heavy acceleration at low revs in high gear, normaly 5th or 6th.

Hi I have a Saab 95 sport tid 150 bhp and it splutters between one and a half and 2 1/2 thousand revs have run a cleaner through it still the same, some times it sounds like the dump valve. You need to check that the EGR valve is operating fully.

What kind of fuel economy does a Saab z19dt get?

The fuel economy isn’t overly bad, averaging 45ish MPG over the last 4000 miles, 50/25/25% (Motorway, town, Country Roads). Z19DT 106’000 miles, 5 years old. To test the lift pump.One needs to measure the fuel pressure as delivered to the fuel rail, it should be 4 Bar.