How do you replace the thermostat on a Ford Ranger?
Remove the wiring harness from the rear of the thermostat (located behind the radiator). Use the socket wrench to remove the thermostat and its gasket. Wipe the are clean with a rag and discard the old gasket. Mount the new thermostat and gasket to the radiator with the torque wrench.
How do you change the thermostat on a Saab 9-5?
Open the cap on the expansion tank and release the pressure. 2. Raise the car. 3. Remove the lower front cover. 4. Drain off the coolant. 5. Lower the car to the floor. 6. Loosen the hose clamp on the upper radiator hose mounting at the thermostat housing. 7. Move the hose to one side. 8.
How are the thermostat housings held in place?
The thermostat housing is held in place with two 13mm and two 10mm bolts. When you install the new thermostat, make sure the vent hole is on top. It is difficult to see the housing bolts and you don’t have a lot of room to turn the ratchet.
How to remove the thermostat housing on a Toyota Camry?
A 10 mm box wrench can be used on the top nut, but there is very little twisting room for the lower nut unless the oil filter is removed. 4. Remove the thermostat housing with a strong tugging or pulling motion. Approximately 1/2 gallon of coolant will leak out when the housing is removed.
How do you replace the thermostat on a Toyota 4Runner?
Install the new thermostat the same way the old one was installed, then install the thermostat housing with a fresh new gasket. Install the lower radiator hose, then slide the clamp on it. Install the tensioner in place, push down on it, then install the drive belt in place.
Remove the wiring harness from the rear of the thermostat (located behind the radiator). Use the socket wrench to remove the thermostat and its gasket. Wipe the are clean with a rag and discard the old gasket. Mount the new thermostat and gasket to the radiator with the torque wrench.
Open the cap on the expansion tank and release the pressure. 2. Raise the car. 3. Remove the lower front cover. 4. Drain off the coolant. 5. Lower the car to the floor. 6. Loosen the hose clamp on the upper radiator hose mounting at the thermostat housing. 7. Move the hose to one side. 8.