What does CPS code mean on Saab 9-3?
The Saab 9-3 is no exception to this rule. That’s because it’s a generic powertrain code. Generic codes tell you that there is a problem, but they don’t really tell you what particular part of the system is throwing the code. OBDII P0340 means that there is a problem with the Camshaft Position Sensor (CPS) circuit.
What causes the p0340 code on a Saab 9-3?
Saab 9-3 P0340 Causes As stated above, the P0340 code is often caused by a failure in the Camshaft Position Sensor itself. Here are the most common causes: Wiring Issue– The Camshaft Position Sensor wiring is exposed to harsher conditions than a lot of the wiring in your 9-3.
What is ABS error code on saabscene Saab?
My ABS+traction+stability control packed up last week and flagged up a error code. The ABS error code can’t be pulled with a standard OBD scanner, you need either an offical GM Tech2 or alternatively an op-com. So I plugged in my op-com into the car and came back with “Rear Left Wheel Speed Sensor open-circuit or low-voltage”.
Where is the wheel speed sensor on a Saab?
The First Stage to verify that the loom is damaged, rather than the wheel speed sensor itself. The wire loom for the wheel speed sensor has two main sections. The first goes from the engine bay to a small connector box on the right hand side (from the back of the car) near the fuel tank.
What does trouble code mean on Saab 9-3?
One of the most common problems with the Saab 9-3 is when it throws the P0700 trouble code. A trouble code is a code thrown out by an automatic transmission whenever it detects in the 9-3 that there is an issue that needs your attention. In the case of the P0700, it is a general code.
Saab 9-3 P0340 Causes As stated above, the P0340 code is often caused by a failure in the Camshaft Position Sensor itself. Here are the most common causes: Wiring Issue– The Camshaft Position Sensor wiring is exposed to harsher conditions than a lot of the wiring in your 9-3.
How to diagnose a Saab transmission range malfunction?
Start by checking the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost to diagnose the P0705 SAAB code is 1.0 hour of labor.
What is the PNP switch on a Saab?
The park/neutral position (PNP) switch includes a transmission range switch. The transmission range switch detects the selector lever position when the shift lever is in the N or P shift position and sends a signal to the Transmission Control Module (TCM). Need more information on how to fix the P0705 SAAB code?