Where to place steering wheel pad when removing air bag?
When removing the air-bag module or handling a new air-bag module, it should be placed with the pad top surface facing up. In this case, the twin-lock type connector lock lever should be in the lock state and care should be taken to place it so the connector will not be damaged. And do not store a steering wheel pad on top of another one.
How to order Saab parts, spares and accessories?
We are not able to accept any customer collections from our premises. Genuine Saab Parts, Aftermarket Saab Parts – Saab Spares, Accessories & Uprated Performance Parts. Quickly delivered via simple online ordering from the comfort of your home, workplace, or even when on the move using your smartphone or tablet!
When to remove the steering wheel and air bar?
The air bag and steering wheel removal is required for a few repairs. When you remove the driver airbag, it is important you disconnect the battery and wait at least 15 minutes for any residual electricity in the system to dissipate.
Where is the SRS airbag control module located?
In most GM cars it is under the driver or passenger seat. Disconnect the positive battery cable and wait 3 min. You are now safe to unplug the airbag control module harness wiring plugs. All airbag srs components must be installed and connected properly before installing the airbag control module.
Is there a recall on the 2003 Saab 9-3?
To let people know the 2003-2011 Saab 9-3 airbag recall is changing. GM safety recall 28810 / Saab safety recall 15041 – Driver’s Side Airbag Inflator: Correction #1 – GM has determined that the models immediately below are NOT subject to the recall. These vehicles do NOT HAVE drivers side Takata steering wheel airbag inflators.
What to do if you have a Saab airbag recall?
Parts to repair your vehicle are not currently available, but when parts are available, your Saab Official Service Center (OSC) will replace the driver airbag inflator on vehicles subject to this recall. This service will be performed for you at no charge.
What causes air bag to rupture in Saab planet?
In some vehicles, the driver airbag inflator may experience an alteration over time, which could lead to overaggressive combustion in the event of an air bag deployment. This condition could create excessive internal pressure when the air bag is deployed, which could result in the body of the inflator rupturing upon deployment.
How do you remove an SRS airbag warning light?
Hold the center section of the wheel in place — where your airbag is located — and locate the screws. Unscrew them. Step 3: Once the screws have been unscrewed, pull the airbag towards you and remove the connectors. Use a pick to slide the yellow clips out in order to remove the connector. You can now remove the airbag.
When removing the air-bag module or handling a new air-bag module, it should be placed with the pad top surface facing up. In this case, the twin-lock type connector lock lever should be in the lock state and care should be taken to place it so the connector will not be damaged. And do not store a steering wheel pad on top of another one.
How do you install an airbag control module?
All airbag srs components must be installed and connected properly before installing the airbag control module. This includes air bags, seat belts, clock spring and impact sensors. Disconnect the battery and bolt down the module and then connect the harness wiring plugs.
How do you install an airbag harness on a car?
You can now install the harnesses and airbag, making sure the bolts are hand-snug and you’re not binding with anything. Reinstall the lower trim piece and reconnect the negative battery terminal and turn on the car. You should no longer have an airbag light on and your horn will now work. Hooray!
In most GM cars it is under the driver or passenger seat. Disconnect the positive battery cable and wait 3 min. You are now safe to unplug the airbag control module harness wiring plugs. All airbag srs components must be installed and connected properly before installing the airbag control module.