How to reset brake light failure Saab 9-3 first generation?
How to reset brake light failure Saab 9-3 first generation. Switch ignition to ON position, don ‘ t start the vehicle. The brake light failure warning light cannot be removed by pressing CLEAR button. To reset the indicator push the brake pedal to clear. CHECK messages.
Why is my Saab 9-3 not showing on YouTube?
If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred. Please try again later. (Playback ID: jqblzASjDVXgUC2P) An error occurred while retrieving sharing information.
How to reset the brake light failure warning light?
The brake light failure warning light cannot be removed by pressing CLEAR button. To reset the indicator push the brake pedal to clear. CHECK messages. When the engine is started, CHECKING will appear on the display for about four seconds, while the SID checks are being performed.
How to reset brake light failure Saab 9-3 first generation. Switch ignition to ON position, don ‘ t start the vehicle. The brake light failure warning light cannot be removed by pressing CLEAR button. To reset the indicator push the brake pedal to clear. CHECK messages.
Why does my Saab check engine light keep coming on?
When your Saab check engine light stays on, it means that the On-Board Diagnostic (OBD) computer has detected a malfunction. The cause could be an engine problem, a fuel system leak, or even an indication of a transmission issue. Since a fault code will be stored in your Saab’s OBD computer, you can use an OBD-II scanner to read those codes.
Where is the fault code stored on a Saab?
Since a fault code will be stored in your Saab’s OBD computer, you can use an OBD-II scanner to read those codes. When your Saab check engine light comes on, you may notice:
What causes MAF sensor to go bad in Saab?
MAF sensor may function fine when the engine is cold then start to malfunction once the engine warms up. A coolant temperature sensor can go bad with time, causing the engine to run rich and preventing it from going into the ‘closed-loop’ mode.
How many warning lights are there on a Saab?
Click a link to learn more about each one. They are roughly ordered by importance, which tends to be by color (red, amber, yellow, orange, green, blue, gray). There are over 30 of them, so search carefully!
What does the ABS light mean on a Saab?
The ABS Light being on means that the ABS wont function. It does not affect the performance of the brakes so if you arent used to having ABS you wont really notice. However, if the car is presented for an MOT then it will fail for having the ABS Light on. Near Side Front Wheelspeed sensor is the usual suspect.
Is it safe to drive a Saab with ABS?
Since being caught out driving in the worst rain I have ever seen, and having to brake heavily the next day, the “anti-lock” light is permanently lit on the panel. Is the car safe to drive like this (I have never had ABS before)?
Where is the ABS controller on a Saab?
Theres an outside chance that the ABS Controller itself has failed. This is usually found either on the back of the battery tray (Pre 95?) or under the false bulkhead with the ECU (on Post 95 cars). You will need to take the car to somebody with a Tech-II and they will be able to read the fault codes for you.
How to replace brake pads on a 2007 Saab 9-3?
And if you are doing a 2007 9-3 and are replacing the rotors, expect to remove the caliper holders using an E20 torx socket (not found in your corner shop) in order to free the rotors. Expect to not be able to budge at least one of the 4 bolts (2 each side) laying on the ground no matter how long your breaker bar is.
When did Saab start putting brake codes on door jambs?
Around 2006, Saab started to put brake codes on the door jamb. Don’t assume if you have a Linear, that you will have 285 mm front rotors and solid 278 mm rears. I have a 2005 Linear (2.0t) with 302 mm front and vented 292 mm rears.
How big are the brake rotors on a Saab?
If you change the brake rotors, make sure that you buy the correct size. Look or measure your current rotors first. Around 2006, Saab started to put brake codes on the door jamb. Don’t assume if you have a Linear, that you will have 285 mm front rotors and solid 278 mm rears.