How do you install a headlight bar on a golf cart?
Connect the two spade connectors from the original key switch to “B” and “I” on the back of KEY-51 (shown in blue). Connect the two spade connectors from the push-pull switch to “B1” and “L” (shown in black). Headlight Bar NOTE: If installing other accessories, do so before installing the headlight bar. 1.
What should I connect my LED light bar to?
Connect your light bar directly to the vehicle battery or another DC voltage source as soon as you open the box. If you use a power supply, make sure its voltage output is within the light bar’s specs. Also, make sure it can supply the maximum current your light bar draws. Tip: Never connect your LED light bar to AC current as it will damage it.
What’s the best way to open a headlight?
Push a flathead screwdriver into the seams between the cover and the wheel wells to expose the hidden bolts so you can loosen them. Lift the bumper cover up and pull it away from your vehicle to remove it. Consult with your vehicle’s manual if you have any trouble finding the bolts on your bumper cover.
How are light bars attached to a car?
Longer light bars typically have studs on each end that fit into right-angle brackets held by screws or bolts attached to the vehicle’s body or chassis. Some light bars have channel mounts. These allow flexibility with regard to positioning the mounting brackets, which slide into the housing channel.
What’s the best way to Open Your Headlights?
How to open your headlights. The process to open up most headlights is the same, here are some tips that should help for most headlights. PREHEAT (very important to preheat) your oven to around 150 degrees F. While it is preheating, remove any screws on the backside of the headlight which hold the lens to the housing (if present).
Connect the two spade connectors from the original key switch to “B” and “I” on the back of KEY-51 (shown in blue). Connect the two spade connectors from the push-pull switch to “B1” and “L” (shown in black). Headlight Bar NOTE: If installing other accessories, do so before installing the headlight bar. 1.
Can you put a headlight in the oven?
While it is preheating, remove any screws on the backside of the headlight which hold the lens to the housing (if present). Once oven is preheated, place one headlight in the oven for ten to fifteen minutes.
How do you make your own bar clamps?
Place the arms on a pipe that is threaded at one end and at least 12″ long to create your own bar clamp. Press the trigger to slide the clamping arm along the bar. Release the trigger and squeeze the pistol-grip handle to lock the clamp in place.