How do you take apart a Prius center console?
How to Remove the Center Console on a Prius
- Park the vehicle in a location away from traffic.
- Open the center console lid, and remove the rug on the floor of the console.
- Pull the cup holder trim from the front of the console by just pulling it off the clips.
- Tilt the entire console back.
How to replace the center console armrest in a Toyota?
Remove the 4 small corner screws on the inside of the NEW console cover – This hold the grey plastic cover to the underside of the leather padded console cover. 2. Remove the 2 screws from the console cover latch 3. Use a flat blade screw driver and pop the grey plastic insert out – It just pops in and out, so you won’t break anything 4.
What makes up the base of an armrest?
Yours may be held in place with different screws, but still likely easy to remove. My armrest is made up of three layers of plastic parts; the part that screws into the base, the underside of the lid, which also include plastic tracks that allow the armrest to slide forward, and the top cover (with the damaged vinyl).
What’s the best way to repair a car armrest?
I chose to staple the vinyl, rather than using spray adhesive, to make it easier to replace the vinyl in the future shoul I need to. Once your done stapling the vinyl inside the lid, now you’re ready to reassemble the whole cover, reversing the steps you used to disassemble.
What do you use to hold vinyl armrest in place?
The vinyl cover is held in place with way too many staples. REmove these staples with a needle nose pliers or a small screwdriver. To give the armrest a bit of cushioning, I used a bit of packing foam that came with some electronic component I bought ages ago.
How do you repair a car console armrest?
REmove these staples with a needle nose pliers or a small screwdriver. To give the armrest a bit of cushioning, I used a bit of packing foam that came with some electronic component I bought ages ago. Place the plastic lid on top of the foam, and then spray the lid with adhesive. i used 3M 90 HI-Strength spray adhesive, which did he job perfectly.
How much does it cost to repair an armrest on a car?
So here is how I reupholstered a damaged armrest in under an an hour, for less than US$5! This is pretty easy, as long as you have the correct tool. I believe I used a 10 or 15 torq bit to remove the three screws holding the armrest in place. Yours may be held in place with different screws, but still likely easy to remove.
Yours may be held in place with different screws, but still likely easy to remove. My armrest is made up of three layers of plastic parts; the part that screws into the base, the underside of the lid, which also include plastic tracks that allow the armrest to slide forward, and the top cover (with the damaged vinyl).
The vinyl cover is held in place with way too many staples. REmove these staples with a needle nose pliers or a small screwdriver. To give the armrest a bit of cushioning, I used a bit of packing foam that came with some electronic component I bought ages ago.