What should the brake fluid level be in a Range Rover?
The basic inspection confirmed that visible brake servo pipework was secure and routed correctly, and that the brake fluid level was normal with no leaks. The engine oil level was also inspected and found to be normal.
What kind of pressure transducer does Range Rover Sport use?
Luckily the Range Rover Sport utilises a quick-coupler within the relevant pipework between the servo and vacuum pump allowing for the insertion of the WPS500X pressure transducer.
What happens when there is no play on the brake pedal?
If the pedal has no free play then it is constantly engaging the brakes, causing them to drag and wear prematurely. If there is too much play the brakes will feel soft and mushy. Slip under the dashboard on the drivers side and look up at the brake pedal.
Where is the pushrod on the brake pedal?
Slip under the dashboard on the drivers side and look up at the brake pedal. Near the top of the brake pedal arm you will see a threaded pushrod that comes out of a rubber boot or metal housing on the front wall of the car and attaches to the back of the brake pedal arm.
What’s the correct pedal ratio for a vacuum brake?
On a power brake system, it is recommended that your ratio be 4:1. Many older vehicles in the 50’s used a pedal ratio of 1:1. This will not work on cars equipped with a vacuum brake booster. Is your brake booster correct for weight of the vehicle?
What happens when your brake pedal goes to the floor?
This failure can create an intermittent brake pedal fade. Pumping the brakes can cause these seals to expand and may help the brake master start working again. When this failure occurs, the brake master cylinder must be replaced with a new unit.
What to do if you have a hard brake pedal?
B) On the last push of the brake pedal, hold moderate pressure on the brake pedal. Don’t push like you are panic stopping, but simply hold pressure like you are sitting at a red light. C) With your foot still on the brake pedal, start the engine and pay attention to what happens to the brake pedal.
What does it mean when your car’s pedal drops?
One of two scenarios is going to happen: 1) If the pedal drops slightly, that means that the booster diaphragms are working correctly as the engine starts to create vacuum and the diaphragms are physically holding. At this point, it must be assumed the booster is working correctly.