Where are the connectors on a Range Rover?
CONNECTOR DETAIL – Details of connectors including a location photograph, face view and pin-out table. NOTE: Before starting electrical checks on the vehicle, ensure that relevant mechanical functions operate satisfactorily. References References to the LH or RH side given in this document are made when viewing the vehicle from the rear.
Where is the OBD2 port on a Range Rover?
OBD2 port Land Rover Range Rover Vogue (2002 – 2012) – Find your plug ! Where is my OBD2 port ? All vehicles are equipped with an OBD port to which you can connect your klavkarr diagnostic case.
Where can I find Range Rover electrical library?
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted in any form, el ectronic, mechanical, recording or other means without prior written permission from Land Rover. CONTENTS RANGE ROVER1
Which is Land Rover diagnostic scanner for your car?
Find a vehicle make rapidly by using the search function in your web browser (CTRL + F) and for more details about the meaning of modes, check out our page OBD modes & PID . Compatible OBD2 ? Where is the OBD2 port on Land Rover Defender (2007 – 2016) ? Where is the OBD2 port on Land Rover Defender (1990 – 2007) ?
Where is the OBD connector on a Range Rover L332?
Click on the label corresponding to your vehicle to see the information. On Range Rover L332 2002-2006, the OBD connector can be found on the lower dash panel, at the position indicated by the arrow on the first picture. The connector is shown on the second picture. Open cover to access the connector.
Where is the ignition switch on a Land Rover?
This is done by performing the following procedure: Put the ignition switch in position II. Disconnect the Data Link Connector (DLC) , which is located behind R/H side of dash, and wait 5 seconds. Reconnect data link connector. Put the ignition switch in position 0 and wait till the load relay drops out.
Where are the trouble codes on a Land Rover?
GEMS Diagnostic Trouble Codes ( DTC ) are stored in the Engine Control Module ( ECM ) and may be retrieved by connecting a suitable OBD II Scan Tool or the Land Rover TestBook Electronic Tester to the Data Link Connector ( DLC ). The DLC is located at the passenger side footwell.
Find a vehicle make rapidly by using the search function in your web browser (CTRL + F) and for more details about the meaning of modes, check out our page OBD modes & PID . Compatible OBD2 ? Where is the OBD2 port on Land Rover Defender (2007 – 2016) ? Where is the OBD2 port on Land Rover Defender (1990 – 2007) ?