How do you lubricate a Sea Doo steering cable?
normally if you remove the steering cable from the ski, and hang it vertically, you can slip a small diameter hose over the top of the shaft, clamp it around the sheath, and fill it with penetrant or wd40, and within 24-48 hrs oil seeps in and frees up the cable.
How to lubricate a boat steering cable gone outdoors?
A little preventative cleaning and lubrication with the right kind of grease can stop this problem before it starts. 1. Unbolt the steering tilt tube (the steering link arm) from the outboard motor using a 9/16-inch socket wrench. Remove the steering arm from the tube and sand it with extra fine sandpaper.
What should I use to lubricate my steering tube?
Remove the steering arm from the tube and sand it with extra fine sandpaper. Clean any hardened marine grease from the inside of the tube by spraying the inside of the tube with a penetrating lubricant.
What’s the best way to grease a steering cable?
Tighten the nut in place. Grease the cable through the newly installed grease fitting with a grease gun, using the marine grease recommended by the steering system manufacturer. If your boat has a rack and pinion helm, it’s a sealed unit and requires no maintenance.
How to remove steering arm from outboard motor?
Unbolt the steering tilt tube (the steering link arm) from the outboard motor using a 9/16-inch socket wrench. Remove the steering arm from the tube and sand it with extra fine sandpaper.
How to lube steering cable on boat the right way?
The Basics On How To Lube Steering Cable On Boat. 1 1. Unbolt. Use your socket wrench to remove the steering tilt tube from its connections on the outboard motor. Then, remove the steering arm right 2 2. Clean. 3 3. Replace. 4 4. Grease.
Remove the steering arm from the tube and sand it with extra fine sandpaper. Clean any hardened marine grease from the inside of the tube by spraying the inside of the tube with a penetrating lubricant.
Unbolt the steering tilt tube (the steering link arm) from the outboard motor using a 9/16-inch socket wrench. Remove the steering arm from the tube and sand it with extra fine sandpaper.
Tighten the nut in place. Grease the cable through the newly installed grease fitting with a grease gun, using the marine grease recommended by the steering system manufacturer. If your boat has a rack and pinion helm, it’s a sealed unit and requires no maintenance.