What is KTM 50 fuel ratio?
Manual says 60:1 with a high quality oil but that sounds a little light on the oil. I use amsoil dominator racing oil. My buddy uses 32:1 in his kids bike but it smokes a lot.
What kind of oil does a KTM 50 take?
Recommended fuel/oil ratio is 60:1 using a high grade 2-stroke oil. Manufacturer recommends full synthetic.
How much is a 2 stroke KTM 50 SX?
2020 KTM 50 SX Claimed Specifications
| Price: | $4,349 |
|---|---|
| Engine: | Liquid-cooled single-cylinder, two-stroke |
| Displacement: | 49cc |
| Bore x Stroke: | 39.5 x 40.0mm |
| Horsepower: | N/A |
Can a KTM 65 run on 50-60 oil?
Newer KTM 65’s run best on 50-60:1 with decent premix oil. Yes, I cringed at first also but after 4 years or so with no piston failures and chasing jetting/performance issues if I changed that ratio up I was converted. It sucked having two mixed gas cans as I wasn’t running that ratio in our 85/125’s..
What’s the gas ratio on a KTM 2 stroke?
I would say in MX and off road 2 strokes that 32:1 was the norm 30 years ago. Most bikes were steel or cast iron cylinders or sleeves back then. Now probably 50:1 is the norm with newer KTM ‘s, at least in the woods from what I read here.
What’s the ratio of 2 stroke oil to gas?
Pour the correct amount of 2-stroke oil into a clean gas can. Add the correct amount of gasoline. Stir or shake the container to mix the oil and gas. Use the mixture within 30 days or add fuel stabilizer to extend the shelf life. 2-Stroke Oil Mix Calculator. For a 50:1 ratio of gas to oil, use 2.6 fluid ounces of oil per gallon of gas.
What’s the ratio in a 10’KTM 65 SX mixture?
I just picked up a left over 10′ KTM 65 SX for my sun and was looking at the fuel/oil mixture. His old KX65 I did 32:1 but noticed KTM is saying 60:1? I was planning on running Repsol full synthetic but little worried about running 60:1. What ratio are you guys running? 32-1 is what we ran in our 65’s and never had any engine issues
Newer KTM 65’s run best on 50-60:1 with decent premix oil. Yes, I cringed at first also but after 4 years or so with no piston failures and chasing jetting/performance issues if I changed that ratio up I was converted. It sucked having two mixed gas cans as I wasn’t running that ratio in our 85/125’s..
Pour the correct amount of 2-stroke oil into a clean gas can. Add the correct amount of gasoline. Stir or shake the container to mix the oil and gas. Use the mixture within 30 days or add fuel stabilizer to extend the shelf life. 2-Stroke Oil Mix Calculator. For a 50:1 ratio of gas to oil, use 2.6 fluid ounces of oil per gallon of gas.
I would say in MX and off road 2 strokes that 32:1 was the norm 30 years ago. Most bikes were steel or cast iron cylinders or sleeves back then. Now probably 50:1 is the norm with newer KTM ‘s, at least in the woods from what I read here.
What should the gas to oil ratio be on a bike?
Conversely, if your bike runs too lean on a 32:1 gas/oil mix and you switch to 50:1 (less oil) it will run richer. That’s why you should run the oil mix suggested by the manufacture, assuming the manufacture got the jetting right, or re-jetting if you change the gas/oil ratio.