Where is the jack in a Porsche Boxster?
The Boxster has a total of 4 designated jacking points. These are located in front of the rear tires and behind the front tires. These spots work well for raising an individual wheel off the ground in order to change a tire.
Is the Porsche Boxster 986 still a good car?
Prices are on the up, as people are waking up to the modern classic appeal of the early 986 Boxster. It’s an older car, but it’s one with fantastic support from dealers and specialists, it has a passionate following and bustling aftermarket industry behind it, and on top of all that, a good one is still a car you could happily use every day.
Is the Porsche 986 a 968 or 986?
One of Porsche’s early Boxster development cars was actually a 968 with a 986 drivetrain under its skin. Parts interchangeability doesn’t end with body components and wheels; the Porsche M96 series of engines can swap around as well, albeit with varying difficulty.
How to tell if a Porsche Boxster 2.5 is a Porsche?
From behind you can identify the Porsche 986 Boxster 2.5 from the plastic rear window, the amber turn signals and the oval exhaust pipe. The Boxster has a small rear wing that deploys automatically at 120 km/h (75 mph) to reduce lift by up to 30 %.
What was the option list for the 1999 Porsche Boxster?
The 1999 model year’s options list includes Speedster cover behind the seats and Litronic xenon lights (M601) with clear lenses. Typical for Porsche, continuous small developments have been made on the engine, gearbox, chassis and interior all the time and also in the middle of the model year.
Can you open the hood of a Porsche 996 Boxster?
Rating is available when the video has been rented. This feature is not available right now. Please try again later. The Porsche 996/Boxster has a powered release for the bonnet/hood/trunk which requires a live battery to be connected to open it. There is a terminal to connect a spare power source should the battery go flat and fail.
When did Porsche change the DME software on the Boxster?
Porsche updated the sensors in the Boxster in mid-2000 and also released a new version of the DME software that is a required update if you are going to use this new and improved sensor (see Porsche Tech Bulletin Boxster 1a/00 2445). Here is a chart that shows the differences between all of the sensors:
Can a Porsche Boxster convertible top be replaced?
In this case, the top transmission, the lever, and the convertible top push rod needed to be replaced with new parts. If your convertible top push rod has broken, then you will need to replace it with a new one. Unfortunately, at the time of this writing, a new plastic ball cup end is only available by purchasing an entirely new rod (about $75).
Where is the pivot ball pin on a Porsche Boxster?
The pivot ball pin (shown in inset) would normally be attached to end of the control lever (yellow arrow), but due to the top getting stuck, it has been broken off. In this case, the top transmission, the lever, and the convertible top push rod needed to be replaced with new parts.