How do you change the fuel pump on a Porsche Cayenne?
Also undo the cable tie (yellow arrow) holding the fuel lines together. Once the lines are removed, grab the fuel pump casing (blue arrow) and rotate it about 90 degrees counter-clockwise. This will release the fuel pump from the tank. Carefully pull the fuel pump up and out of the tank. Be prepared for some fuel to spill out.
How do you remove a fuel filter from a car?
Press the tab on the fuel line connector (yellow arrow) and pull it off. Both sides of car: You will now need to loosen and remove the retaining rings (green arrow) that hold both the FPR and the fuel filter in the fuel tank.
Where is the disconnect point on a Porsche Cayenne?
The disconnect point is located under the driver’s side carpet, near the seat. You’ll see a slit in the carpet, pull it up and you’ll see the 13mm acorn nut holding the ground lead to the frame (green arrow). Remove the nut and pull the lead up off the post.
How to remove fuel filter from Porsche Cayenne?
Both sides of car: You will now need to loosen and remove the retaining rings (green arrow) that hold both the FPR and the fuel filter in the fuel tank. Porsche calls for special tool T10202 to do this, although you can loosen the ring by placing a screwdriver on the edge of the ring and using a hammer to tap it loose counter-clockwise.
Can you replace the fuel pump in a Cayenne?
The design of the fuel tank in the Cayenne allows you to not only replace the fuel pumps, but also the fuel filter and the fuel pressure regulator if needed. In this article, we will go over the steps involved with replacing both fuel pumps, the fuel filter and also the fuel pressure regulator (FPR).
The disconnect point is located under the driver’s side carpet, near the seat. You’ll see a slit in the carpet, pull it up and you’ll see the 13mm acorn nut holding the ground lead to the frame (green arrow). Remove the nut and pull the lead up off the post.
Press the tab on the fuel line connector (yellow arrow) and pull it off. Both sides of car: You will now need to loosen and remove the retaining rings (green arrow) that hold both the FPR and the fuel filter in the fuel tank.