What to do if your ignition key does not work?
Take some lock lube spray and spray a bit in your ignition key slot. Then take the key and insert it in and out a few times. This may release a stuck contact in the ign. switch. The chime will also sound if the lights are left on…worth a check too.
Can a Porsche ignition switch be put back together?
The switch has a locating pin cast into the housing, so there is only one way that it can be put back together. Replacing the electrical portion could most certainly solve some ignition and starting problems. Electrical systems flickering on and off as you turn the key are a good clue that your switch is worn.
Why is my ignition not working on my Porsche?
One of the most common electrical items to fail on some of the older Porsches is the ignition switch. This failure can show up in any number of ways. The car can refuse to start some of the time, the key may not turn too easily in the ignition, or strange electrical problems may appear.
Why does my car not start when I put the key in?
Putting the key in the ignition switch and starting the car feels like second nature. However, if your car has ignition switch problems, you may not be able to start the car at all. Ignition switch problems can also cause issues on the road, such as unexpected shutdowns or electrical problems.
Can you replace the ignition switch on a Porsche Boxster?
For 2005 and later models, the entire ignition switch / steering lock assembly was removed from the car, and replaced with an electro-mechanical solenoid that locks the steering rack instead. You can only remove the locking mechanism after dismantling the entire steering system.
One of the most common electrical items to fail on some of the older Porsches is the ignition switch. This failure can show up in any number of ways. The car can refuse to start some of the time, the key may not turn too easily in the ignition, or strange electrical problems may appear.
What to do if your ignition switch is worn out?
If your key doesn’t turn too well in the ignition, then chances are you have a worn out tumbler. You can attempt to rekey and refurbish the tumbler yourself, but the process can be quite difficult. It requires that you drill out a pin that has been pressed into the housing.