What to do if your Porsche 911 starts leaking oil?
Right near the crankcase breather hose is the oil pressure warning lamp switch. Not only does this component often begin to leak out of its housing, but it also can leak at the connection to the case. The fix is to replace the entire sender (about $10).
Can a cracked cylinder head cause an oil leak?
This is not common, but it could happen, so it should not be forgotten. If the engine cylinder head or the engine block is cracked, oil can leak from the engine and even enter the cooling system. This can especially happen if you, by some time, didn’t have enough coolant in the cooling system, which caused the coolant to freeze.
Can a lack of oil pressure cause a repair?
Oil pressure – or more precisely the lack of it – in certain parts of your car’s engine can become a major repair nightmare. All engines lose a certain amount of oil pressure over time as normal wear increases bearing clearances.
When was the 996 oil leak on the Carrera 4?
VIN Option Lookups (limited) 996 oil leak By Rise1210, November 18, 2011in 996 Series (Carrera, Carrera 4, Carrera 4S, Targa) Share Followers0
When was the 996 oil leak in GT2?
911 996 Series (Carrera, GT3-1, TT, GT2) (MY1998 – 2005) 996 Series (Carrera, Carrera 4, Carrera 4S, Targa) 996 oil leak The RennTech.org community is Member supported!
How to help the 996 oil leak community?
996 oil leak The RennTech.org community is Member supported! Please consider an ANNUAL donation to help keep this site operating. Click here to Donate Welcome to RennTech.org Community, Guest There are many great features available to you once you register at RennTech.org
Is there a 996 series of Carrera 4S?
Content titles and body Content titles only 996 Series (Carrera, Carrera 4, Carrera 4S, Targa) All Activity Home 911 996 Series (Carrera, GT3-1, TT, GT2) (MY1998 – 2005) 996 Series (Carrera, Carrera 4, Carrera 4S, Targa) 996 oil leak The RennTech.org community is Member supported!
What’s the part number on the Porsche 911?
The part number for this rocker arm shaft seal is 911.099.103.52, and you need two of them for each rocker for a total of twelve. Another common oil leak comes from the oil return tubes.
Where is the oil cooler on a Porsche 911?
It should be noted that all o-rings when installed should be liberally coated with fresh, clean motor oil prior to installation. Located in the same general area is the oil cooler. The three seals that mate the oil cooler to the engine case also have a tendency to become brittle and leak.
Where are the oil feed lines on a Porsche 911?
On the top-rear of the engine are the camshaft oil feed lines. These lines supply the cam towers with oil to lubricate the cams and the rocker arms. These lines have a tendency to vibrate and develop leaks over the life of the motor.
Is there an oil leak in my Porsche 911?
The issue affected many model years of the 911 — 1999 through 2010, and 2014. The leak appeared in 3.4 liter, 6-cylinder Porsche engines, and occurred at an average of 74, 600 miles. Other owners experienced engine oil leaks at the rear main seal, or at the support cover for the o-ring.
What are the most common problems with a Porsche 911?
The number one reported problem with the 911, the leak at the oil separator, cost owners an average of $88 to $111, although one owner complained his repair cost over $2,000. For over four decades, the Porsche 911 Turbo has been synonymous with relentless performance.
Where is the oil pressure switch on a Porsche 911?
On early cars, the oil pressure sending unit which also often leaks, was installed in this location. Directly adjacent to the oil pressure switch is the thermostat, which controls the flow of oil to the oil cooler.
The part number for this rocker arm shaft seal is 911.099.103.52, and you need two of them for each rocker for a total of twelve. Another common oil leak comes from the oil return tubes.