What makes a Cayenne radio reception not good?
The antenna will not have good reception if it forms a repetitive circle. You want the antenna to run back and forth (as pictured) in opposite directions so that the signal does not “gain” on itself. In a circle, the signal is all traveling in the same direction (bad).
Can a double DIN radio be installed on a Cayenne?
Cayennes ship with both double DIN size radios as well as single DIN size radios. This radio Kit will allow for a double DIN size radio to be installed into either. 1. Remove the plastic trim that surrounds the radio.
How do you remove the trim from a Cayenne radio?
Remove the plastic trim that surrounds the radio. This is done by inserting a soft plastic pry tool between the trim and the radio console. It is easiest to start at the bottom near the climate controls and work your way around the top. The trim is quite secure. Once you get part of it to come loose, the rest will come off easily.
Where is the Red Wire on a Cayenne?
Connect the red wire to the Black wire in the vehicles PSM button located above the radio location. Once connected, reinforce the connection with a small zip tie. Note: If installing a camera system, the camera will also require 12 volts accessory power as well. Make those connections here at the same time. 1. Mount the Side Brackets
Where does the microphone wire go on a Cayenne radio?
Use a long ziptie to pass the microphone wire through the dash and above the gauge cluster. Once above the cluster, use the same ziptie to pass the wire to the right and down to the radio cavity. Just like the satellite antennas, you can bundle up the excess wire above the gauge cluster.
Is the PCM on my 2005 Cayenne working?
I have a 2005 cayenne s. The PCM had been working fine up until the last few months. Nearly everytime you get into the car now and start it up the PCM comes on however the SAT NAV, AMPLIFIER and PHONE will not work. PHONE, NAVAGATION & AMPLIFIER NOT AVAILABLE.
How do you install a radio in a Cayenne?
If your vehicle has a pocket below the radio, remove it as well. 1. Remove the plastic cover above the gauge cluster. This is done by inserting a soft plastic pry tool in the top center and pulling down. Next pry the outside corners of the panel up and over the panel that is below.
Remove the plastic trim that surrounds the radio. This is done by inserting a soft plastic pry tool between the trim and the radio console. It is easiest to start at the bottom near the climate controls and work your way around the top. The trim is quite secure. Once you get part of it to come loose, the rest will come off easily.
Connect the red wire to the Black wire in the vehicles PSM button located above the radio location. Once connected, reinforce the connection with a small zip tie. Note: If installing a camera system, the camera will also require 12 volts accessory power as well. Make those connections here at the same time. 1. Mount the Side Brackets